2011 Nissan Navara D40 with a crank no start issue

  Рет қаралды 63,948

The Automotive Technician

The Automotive Technician

Күн бұрын

Пікірлер: 30
@kevinpalmer7452
@kevinpalmer7452 3 жыл бұрын
Never would of thought of disconnecting cam sensor what a great tip thanks 🙏
@ukcitizen1158
@ukcitizen1158 Жыл бұрын
Guys, FYI,, if the issue on the Crank side, it will start if the Crank Sensor is disconnected also.
@kylejeffrey3894
@kylejeffrey3894 5 ай бұрын
Thanks for this one. We have a D22 YD25 in that will start up but cuts out when idle drops below 1000revs, if you flick the heat switch it will idle forever. Until you hit the clutch and it drops the revs. If we unplug the cam or crank sensors individually it will start up and idle fine but plug it back in and it goes bad again on next start. Will scope it in the morning and have a look.
@amadoudiallo7826
@amadoudiallo7826 8 күн бұрын
thanks for the education
@matrongokea6191
@matrongokea6191 9 ай бұрын
Great info I have a 2007 navara Spanish make. Stalls from a cold start.
@MrConspark
@MrConspark 3 жыл бұрын
Great video once again, thanks guys 👍
@Lambros_Stefaneas
@Lambros_Stefaneas 3 жыл бұрын
well done man. very good video. what was the actual problem?the chain or the variable timing ?
@romanosautomotive
@romanosautomotive 3 жыл бұрын
Lambros, it's Rob here. The fault was a stretched timing chain although the customer did not want to proceed, so there was no strip down to show in the video.
@Lambros_Stefaneas
@Lambros_Stefaneas 3 жыл бұрын
@@romanosautomotive Thanks a lot for the answer, Rob. I like a lot the way/procedure that you approach the problems(which is the right way 😂).You are a top level technician. Keep feeding us with great videos/lessons 😂🤣
@johnm1397
@johnm1397 2 жыл бұрын
What is the cause of problem sir timing chain or cam sensor?can u tell me thank you 😊
@damianjones6546
@damianjones6546 Жыл бұрын
​@@romanosautomotiveI've got a Pathfinder with the same issue. I'm not sure what to do now, it's a big job replacing the timing chains!
@GabosekweDesmond
@GabosekweDesmond 11 ай бұрын
yes I have the same problem but when I plug the camshaft sensor it cuts the engine off so what could be the problem...
@DJ-tn7vj
@DJ-tn7vj 3 жыл бұрын
Great tip. Will try it. Never thought about unplugging the cam but question. Would it drive or move without the cam being disconnected.
@محمدفتحى-ث4غ
@محمدفتحى-ث4غ 2 жыл бұрын
Please, I want you to tell me the reason for this problem, and thank you
@billyhenabee7190
@billyhenabee7190 2 жыл бұрын
I need your help. I'm working on a Nissan Urvan bus E26.and this DTC P1275 came on.and I don't know what it is.? So please can help me diagnose this issue thanks.
@huymanhnguyenVN
@huymanhnguyenVN 2 жыл бұрын
My car nissan (D40) don't report error. By it lost power. Normal when engine rpm is 800 then intake manifold absolute pressure kpa about 97. But my car has 88-90 when engine rpm is 1000. When my car is Climbing uphill pedals on the accelerator and the engine speed does not go up.How do you know, Please show me. Thanks
@faroukkhan6777
@faroukkhan6777 2 жыл бұрын
Thanks excellent
@DanWallis86
@DanWallis86 3 жыл бұрын
Interesting video. Very strange that it starts with the Cam sensor unplugged but not plugged in.
@omarbastri5983
@omarbastri5983 2 жыл бұрын
nice video thanks sir
@michellenattrass8466
@michellenattrass8466 Жыл бұрын
Hey mate , I have a yd25 pathfinder that cranks but no start ! I have changed fuel filter , suction control valve and cleaned maf and ect but still to no avail . How can I check timing on these engines without a full tear down . Is that possible, I have tried to start it with cam sensor unplugged but no go , so far I suspect pressure relief valve on fuel rail , injectors or timing , what’s your experience and advise Please keep in mind I work in the industry and will be doing this repair in the driveway 😅
@oswaldoof
@oswaldoof Жыл бұрын
I am from Brazil. After replacing the SCV, because the engine was stalling in idle, the engine of my Frontier (Navara) do not start, even with the old valve. Please, any advice?
@andrews9132
@andrews9132 3 жыл бұрын
Hi great video,what year model is that?
@TheAutomotiveTechnician
@TheAutomotiveTechnician 3 жыл бұрын
2011 Nissan Navara D40 2.5L YD25
@DavyDiag
@DavyDiag 3 жыл бұрын
Nice one!
@rubzgajetz9680
@rubzgajetz9680 Жыл бұрын
Sir I have problem same crank but not start navara d40 2009 model
@pholosomichaelmoilwe3813
@pholosomichaelmoilwe3813 11 ай бұрын
Did you win,please share if you did
@koboxecuwiringtraining9735
@koboxecuwiringtraining9735 3 жыл бұрын
good
@mubuyaetasitwala1622
@mubuyaetasitwala1622 2 жыл бұрын
My Nissan navarra starts then dies what can be the problem
@kairad3110
@kairad3110 Жыл бұрын
Is the issue fixed if so what was problem????
@mrilikeskateboards
@mrilikeskateboards 2 жыл бұрын
"let's unplug the cam sensor and see what happens" *turns key and puts a hole in the piston* 🤣🤣 nah good to know, getting a Navara now, crank no start, cheap as chips project. Guy reckons fuel pump, but never know until you know
You won't believe what's causing this No start!
22:01
DiagnoseDan
Рет қаралды 710 М.
How to diagnose Nissan engine faults Navara Pathfinder Cabstar YD25
5:05
West yorkshire engine services
Рет қаралды 260 М.
人是不能做到吗?#火影忍者 #家人  #佐助
00:20
火影忍者一家
Рет қаралды 20 МЛН
Crank No Start That No One Could Fix  SBQM Free Video!
32:56
Schrodingers Box
Рет қаралды 905 М.
2010 Nissan Navara D40 With A Crank-No Start. Lost Communication
25:49
Engine Cranks but Won't Start? Common Reasons Why Your Car or Truck Won't Start and the Parts Needed
6:39
1A Auto: Repair Tips & Secrets Only Mechanics Know
Рет қаралды 1,8 МЛН
Crank No Start (The Most Common Causes)
7:36
EasyAutoFix
Рет қаралды 718 М.
Nissan Frontier Turn Key NO START. NO CRANK. IPDM Video 1 Of 2
5:11
The Final FRONTIER...No-Start, No-Comm (Part 1)
26:02
Pine Hollow Auto Diagnostics
Рет қаралды 76 М.
Car Cranks But No Start? Diagnose And Fix Now!
9:12
Budget Mechanic
Рет қаралды 647 М.
人是不能做到吗?#火影忍者 #家人  #佐助
00:20
火影忍者一家
Рет қаралды 20 МЛН