2011 Toyota Tacoma 2.7L 4 cylinder injector replacement

thank you for watching!!!!!
If this video was helpful to you and if you would like to place a donation, here is my Venmo and PayPal information. Or I would really appreciate it if you could share my KZbin channel on your social media. Links will be on the bottom.
#jabothemechanic #toyotatacoma #injector
venmo.com/code?user_id=265066...
www.paypal.me/urbanautomotive

[@hector7182]

Dude! Thank you so much for doing this video! It helped so much changing out my fuel injectors on my 2005 Tacoma 2.7L. The only thing I did differently was to unbolt the two screws that hold the Fuel Pressure Pulsation Damper on the fuel rail. Doing that made torqueing the Fuel Rail Spacer bolts down easy with my torque wrench. I used your trick with the dielectric grease and put a thin layer on the o-ring before putting the Damper back on the rail and all other o-rings for that matter. Worked like a charm! But other than that, all other step were identical. The worst part was pulling the damn connectors off the fuel injectors and a couple of other ones as well. I did take my time to clean the throttle body and used your advice about the gasket. Mine was flat with no lip so I swapped it out. Anyone cleaning the throttle body, I would suggest you do not open the flap quick when you are cleaning it out. If you don't know what I mean, watch The Car Care Nut videos on youtube. Again, thank you so much dude! I really appreciate your video! Torque specs: Fuel rail spacer bolts x 2 - 108in/lbs Fuel Pressure Pulsation Damper bolts x 2 (The thingy that goes on the fuel rail) - 75in/lbs Throttle Body Bolts and Nuts x 4 - 80in/lbs Intake Hose & Throttle Body Hose Clamp bolts x 2 - 44in/lbs Fuel Injector OEM # - 23209-79205 Throttle body Gasket OEM # - 22271-75070

[@jamesrooney7689]

excellent thank you very much

[@DCGreenZone]

Just did my injectors on my 2006 Nisan Altima, V6, what a pain. Have done the rear valve cover THREE times, no fault of my own, using after market parts, it's what I can afford and what is justified for this year vehicle. Noticing now, when stopped at a red light, the engine seems to be laboring a bit, suspect MAP or MAF sensor, but don't have a way to tell yet, no codes. Any input would be appreciated, perhaps you've run into this before. It holds RPM, it just feels like it is working too hard, maybe fuel pressure, lost at this point. Thanks in advance.

[@jdrains16]

How would you do the idle relearn on a manual?

[@issaccruz4350]

Do I have to disconnect any fuses before attempting this on my truck bro?

[@The_RC_Guru]

No.