Рет қаралды 112
I put "2012-2015" in the video because the 2010-2011 Prius has slightly different lights.
LED installation guide:
Use eBay or Amazon to search for these parts! Ex. "h11 led," "9005 amber led," etc.
High beams (9005)
Low beams (H11)
Fog lights (if equipped) (H16)
License plate lights, parking lights, map lights, and courtesy lights (2825) -- there are eight.
Front and rear turn signals (7440A) - you will need to get two pairs for the front and rear. You will need a new turn signal relay or some resistors (I used resistors). I have the instructions at the bottom of this description.
Reverse lights (7440W)
Dome light (DE3175) - Some of them may require bending the connector with your finger so the light can fit into the socket.
TURN SIGNAL INSTALLATION INSTRUCTIONS:
LED turn signals are the most complicated lights to install with LED conversions. You will need resistors (or a single LED turn signal relay if you don't want resistors) for your turn signals. Without them, your turn signals will hyperflash (blink too quickly), and the fuse might blow. The reason for this is because the load is too low (LEDs use less power than halogen) and the car will think the light is about to go out and do that as an indicator.
First, replace the halogen bulbs with the LED equivalent. You will need to strip the two wires and connect a resistor to both wires. I recommend soldering the wires together so they can stay connected over time. Also, taking some panels off in the hatch might be necessary if you want more room. The resistor can just hang from the wires if you want. However, they do get warm. I haven't had an issue with doing that. You will need to take the front bumper off to install the front turn signals... unfortunately. The positive side of this is that there will be a lot more room! There are plenty of videos on KZbin showing how to remove the front bumper.