Replacing the front brake pads and rotors on a 2013 VW Passat SE with the 2.5 L engine.
Пікірлер: 16
@pastorfred34608 ай бұрын
great video...I'd like add a couple suggestions for people doing this for the first time...always a good idea to remove the cap on your brake fluid reservoir and then sit cap on top so air can get out but no debris can fall in as you retract the caliper because this forces fluid back toward the reservoir. Also, always spray the new rotor with brake cleaner because they come from the factory with a coating of light oil. And, it's a good idea to put grease on those caliper pins, the non-threaded surface. And finally, pump the brakes in the driveway with the car running while in park until you feel resistance before you start driving.
@cruisinwithgreg8 ай бұрын
Thanks for the additional info!
@foxxxyred16622 ай бұрын
Do I need to remove the cap if I'm only replacing the brake pads and not the rotors?
@pastorfred34602 ай бұрын
@@foxxxyred1662 always a good idea because you will need to compress the piston on the caliper to make room for the new pads which forces brake fluid back into the reservoir.
@Sheriff_California2 ай бұрын
Super video 🤙🏼🤙🏼
@cruisinwithgreg2 ай бұрын
Right on!
@glenfishing5 ай бұрын
Thanks Greg.
@pocketfulof-dinerobeats3 ай бұрын
Thanks greg. Make sure yall hit yall hit the like button. 😎👍🏾💯
@isiahsmith6734 ай бұрын
auto zone gave me front pads with a wire, i would assume break sensor? are they the right pads> 2013 vw passat tdi se
@cruisinwithgreg4 ай бұрын
Yes the ones I got from there also had the sensor wire. If yours doesn't have a brake wear sensors, it is on to cut that off. It would be the same as if they weren't there at all. But verify yours doesn't have brake sensors first!
@foxxxyred16622 ай бұрын
If I am just replacing the brake pads, do you need to take the cap off of the brake fluid reservoir? If so, will I need to bleed the brakes, only just for replacing pads?
@cruisinwithgreg2 ай бұрын
You will not need to do a brake bleed if just replaying. You only NEED to bleed the brakes if you introduce air into the system like replacing calipers.
@phoenixmckay64828 ай бұрын
Can this video be followed for the rear brakes aswell?
@cruisinwithgreg8 ай бұрын
Hey! It is a little different to do the rears, not exactly the same! If you can do the fronts you can definitely do the rears though!
@RestInPisKA2 ай бұрын
Now take your 20.... (21\22) mm soket and a bar and remove caliper bracket bolts???? Can you please write a comment what size is it?
@cruisinwithgreg2 ай бұрын
Hey the caliper bracket bolts are 21mm as stated in the video!