2014-15 Silverado Morimoto XB LED fog install

How to instal your fogs from start to finish.

[@danielbryan8300]

For someone watching, you can do this without removing the front bumper. You have to unblolt the bumper support and the 7 15mm bolts loose and wiggle the bracket loose then do everything shown for the bracket then you have to wiggle the bracket back up. The first side took me about an hour, but after I figured it out the other side took about 30 min. Also the lights are awesome!

[@8Erock8]

Just replaced mine on my 2015 Silverado food there same thing you did and it was easy no trouble at all

[@WolfMcQuaid]

I can confirm that I was able to this job without taking the front end off and without jacking up the truck. (Stock suspension) First take off the support bar (3 bolts) that’s underneath the fog light housing and then start taking off the bolts that support the fog light housing. Wiggle it out is easy but to wiggle it back after doing the fog light swap, it’s almost impossible not to scratch the plastic ferring a little. Not a big deal and unless you walk right up to it you will not notice. Thanks for the video. It told me exactly what bolts I needed to take off. 👍👍

[@lancediaz866]

You’re insane…..no need to remove bumper!

[@KableTac]

Even after watching this I'm still confused why all of this was necessary. You can pop the fogs out from the front without even removing the bumper, and all you essentially did was put the clips onto the new fog light which pops out with the fogs. You turned half a day into a 5 minute total job, including the upload.

[@philsheridan5040]

Have you tried it? There is absolutely no way you are pulling these 2015 fog lights out of the front of the bumper. You put a video together and prove it and I will give you 50% off on these things. Telling you though, you won't be able to. On a gmt 900 (nnbs) yes it is a 5 minute job but not the new ones.

[@KableTac]

+Phil Sheridan I'm not trying to prove anything, I have LEDs in my stock fogs which better match my headlights anyway. It just sparked my interest on the style for some setups. But I'm not blind, the only difference between nnbs and nnnbs is the well on the front, it's straighter than nnbs. And even in the case that you couldn't remove it from the front, you could have just as easily stuck your hand under the bumper (and my truck has a 4.5/7 drop and I could still do it on the ground so accessibility is no excuse) and pushed them out exactly as you did anyway without removing the entire bumper and bracket assembly. Yeah, removing the entire thing is better in the ease of holding it in your hand, but the time you spend getting to that ease you'll have done both before you even got half the bumper off. I mean you say you can't do it without doing all this, why? what's holding everything back? The faceplate? Looks like more than enough room to push the fog through once it's unclipped where you can wiggle it out.

[@philsheridan5040]

+Kable the entire border of the fog light is covered by the plastic surround. Do you have a 2014 (nnnbs)?

[@Unknown--error]

Anyone reading comments, here is a massively easier tutorial: kzbin.info/www/bejne/bYa9oIKAm7mDY7c