2015 Chrysler 300c 3.6 ( Bad oil pressure sensor?)

[@7.62Ak]

What was the code it was throwing?

[@anthonyhuerta6122]

I just replaced my oil pressure sensor on a 2013 Chrysler 300 with the 3.6 l pentastar engine..after I put everything back together I started the car it cranked over but started making a clacking sound like something was in the motor ,so I immediately turned it off ..waited a few minutes and started it again and made same sound,so I then took everything apart again to mk sure it was put back together correctly,double checked ,tried to turn car on again but not cranking over at all like the starter wasn't working..I took starter off wich was a pain int the ass,lol,took it and got it tested and it was good so I threw it back on still same problem car not turning over at all ..all the lights and radio come on so I'm getting voltage ,I just don't know what could be the issue

[@hittz8331]

Did you possibly drop something into the open intake?

[@19HarDMaN97]

You did grape!

[@richardcastro166]

You located in Los Angeles ?

[@Splursy]

I just had the light today

[@djeldorado1]

Do you have to remove the intakes to check that sensor? Absolutely necessary to remove?

[@aksgarage3230]

Yes you have to remove the intake. But do not check the fences just change out the cooler all in one piece

[@aksgarage3230]

Check the sensors

[@richardcastro166]

What sounds does it make

[@aksgarage3230]

It didn't make any sounds. It read low oil pressure on the dash board. The whole unit needs to be replaced .

[@richardcastro166]

@@aksgarage3230 ooo ok Thanks 🙏

[@marcusmobliemechanicmacon1778]

We don’t care what the last mechanic did .when you make videos please focus on the content at hand . Thanks for the location .this video could have been 2 mins 😑cut out all the extra talking you’ll get more views