2015 Mazda CX-5 Coolant Drain & Fill

[@ginfioanswers7062]

Does your car not have the wire harness in the way? How did you remove the reservoir so easily ?

[@PaulNaylor3]

It’s been a little while since I did this job but I watched the video and you can see that wiring harness from time to time between the four minute and six minute mark on the video. If I remember right, I think I was able to stretch it out of the way to remove the reservoir.

[@puddleduckist]

If you add another oring it will mske it a tighter seal. I just ordered one of these funnels to do the same thing on my 17 mazda 6 gt. Thanks for sharing!! Nice job!

[@PaulNaylor3]

Thank you.

[@carmenspina7967]

Thanks for sharing....

[@PaulNaylor3]

You’re welcome

[@hithere9495]

The shirt 😂

[@PaulNaylor3]

Dad jokes are in full supply 😂

[@scotthayesproductions5715]

So, this takes about 5qts or slight more to fill the reservoir?

[@PaulNaylor3]

I summarize what I used with some advice at 26:40. You can buy 1 gallon and see if you need more.

[@jomsti4840]

Did you have any engine cooling problem afterward even you did not bleed out the cooling system?

[@PaulNaylor3]

No, I checked the coolant level frequently for a few days after and didn’t have to add any more coolant.