This video explains the process invovled in replacing the transmission fluid in your 2017 ford escape 2wd (front wheel drive.) I learned that the 2wd versions of the ford escape do not have a PTU or a rear differential.
Пікірлер: 36
@helifixer20610 ай бұрын
Good video, my escape also had that weird cap as well, I had a bunch of hoses and crap in the way so I pulled the airbox to get better access to that cap. I skipped the level check, i measured exactly what I drained and put exactly that amount back in (mine was 3.75 Liters, 3.3 quarts). Now you have me doubting I put enough in, but mine is an 4WD version so the trans may be different. This was the first change that my escape had ever had so it was factory filled last so I hope it is right. Save a lot of money doing this stuff yourself that is for sure.
@AT-wl9yq7 ай бұрын
You didn't mess up. A drain and refill on your vehicle is about 3.5 qts. You just need to make sure the new and old fluid are the same temperature. If you remove hot fluid and refill with cold, you'll over fill the trans because the fluid expands. Your vehicle is reasonably forgiving when it comes to setting the trans fluid level, but you can't always do it this way. On some of Fords other vehicles, you have to be exact. That means monitoring the parameter ID for transmission fluid temp with a scan tool while the engine is running. The range has to be between 110 and 116 degrees to check the fluid level. After that, a relearn procedure has to be done. If everything isn't just right, you'll have drivability issues.
@SuperFlint889 ай бұрын
Ill be doing mine in a couple of days. 1st time doing it after 45k miles 2017 se 1.5l. Dealer ask for $500 to do it. You save me time man great video.
@renelopezzarate65012 ай бұрын
Hello, that's great, l wanted to change the oil on my truck but l didn't know where to put the oil, and l saw your video and l already saw how to do it, thank you very much
@cozzconM2 ай бұрын
Thanks... I have the exact same configuration... went smooth.
@rolexchristians43257 ай бұрын
Thank you, that was super helpful!! Cheers
@donfamily7779 ай бұрын
Great job! Thanks!
@TheJawtech10 ай бұрын
I just did this myself on a 2.0L Escape - had to do it 3 times but it stopped the RPM surging at a steady speed. Mine is AWD, i'm going to takle the PTU next.
@drew12514 ай бұрын
The ford mercon lv stuff comes in a 1.25 gal container which is 5 quarts instead of the Valvoline stuff which is just 1 gal. Dude same boat I see all these videos you’re the only guy with my cap, I had to take the air box out because the extra wires too…I took the wheel off(a 10 mill hex head worked for me) used the scissor jack that car came with instead of my normal jack with wheels and used a few 2x4s next to it for support …pain in the butt…but 50bucks I just use 1 fomo merc lv once a year (knock wood so far so good) I have a fwd so I don’t have the ptw in the rear of the vehicle good luck with that one …
@newfie-dean58034 ай бұрын
To be at the right level you need to have a slight dribble of fluid coming out when it’s at operating temperature. Having none come out means it’s a bit low. I would also recommend using Mercon LV fluid too. It’s reasonably priced on RockAuto and it’s advised to only use ford fluid in this transmission.
@CreatingExcellenceАй бұрын
Mercon LV is a type of fluid. So if it specifies Mercon LV on the bottle, you’ll be good.
@DG-fe4ht9 ай бұрын
The car need to be RUNNING & LEVEL in order to check fill level!!
@thefunkyt7 ай бұрын
Did you post the PTU change?
@loboluna48898 ай бұрын
Gracias 🙏 thanks ❤️
@JamesWageloch3 ай бұрын
Did you do the other Video Champ? power unit?
@michaelgoldman38122 ай бұрын
Aren't you supposed to run the engine with transmission in neutral to determine when the transmission is full?
@CreatingExcellenceАй бұрын
Yes
@sc32valve8 ай бұрын
You should have topped off the trans after it was at operating time. You should have also flushed it 3 times to get about 85% of the fluid changed. Flushing it once like you did only changed about 30% of the fliud. You actually just contaminated the new fluid because you didn't flush enough times to get what's in the torque converter. Flush 2 more times to change almost all the fluid. One flush isn't enough. 1 flush = ~30% 2 flush = ~60% 3 flush = ~85% Make sure to take for a 10 min drive between flushes
@Bbbrrr1218 ай бұрын
You are wrong. Drain it 1 time = you change it about 50% not 30%. The total capacity of the transmission fluid is 9 qt. When you drain, more than 4.5 qt comes out. If you do it twice, about 75-80% is changed. Read the manual and Do the math!
@TG-jt8vb3 ай бұрын
FYI, don't confuse flushing with drain and fill. Flushing is not recommended.
@CreatingExcellenceАй бұрын
Not flush, drain and fill but yes 3 times is best
@davidturk61709 ай бұрын
You didn’t put six quarts in. The larger container is one gallon (4 quarts). So you put in five quarts. It takes about 4.25 quarts. Suggestion: use vice grips (locking) versus pliers. Last I put Seafoam transmission conditioner (whole can) in first, then added the four quarts.
@Daytonadanny7 ай бұрын
I'm thinking of doing this for my friend's parent's 2017 Ecoboost titanium, they bought it with about ~35,000 miles. It's over 120,000 and they haven't changed trans fluid. Should I put some seafoam in?
@DIYTechnician9877 ай бұрын
You’re right, I misspoke about six quarts. The owners manual says 5 quarts and I added back exactly that with whatever excess coming out. I am so used to doing engine oil which is 5 quarts per jug.
@XxNeonRayxX3 ай бұрын
I wouldn't even touch it cuz if it hasn't been change at all n its 120k miles that old fluid is keeping that transmission together u would have to get a whole new 1 @Daytonadanny
@FEDCaleb9 ай бұрын
Bro dipped his camera in dielectric grease before he pressed record
@debbieraeke8 ай бұрын
What does the car tell you if it's no does it tell you if it's low I've had my car for 3 years so I guess I should have it done
@luceholiday20103 ай бұрын
Can you just measure the fluid that comes out instead of taking off the check level plug?
@luceholiday20103 ай бұрын
I just did it on my 1.5L 2017 Escape. It took 5 quarts which is what yours had, not 6 (4 quarts in a gallon)
@ait97742 ай бұрын
You could IF you know that the trans fluid was at the correct level. The 6F35 transmissions can experience problems if underfilled.
@jojojordan55575 ай бұрын
The level plug behind the tire is only on 2.0 engines.
@JimN_AustinTx5 ай бұрын
My 1.5L had the exact same trans and plug.
@luvthesnow4 ай бұрын
@@JimN_AustinTx You are correct sir!
@TG-jt8vb3 ай бұрын
Total hack job. Get some ramps next time. For the initial change at first if it's never been touched do a drain and fill 3x. Then every 15-20K after that do a drain and fill 2x. These 2nd gen 6F35 transmissions used in 2013 and newer Escapes are complicated and the only fluid you should use is Mercon LV or an equivalent licensed product such as Mag 1, Kendall, or Phillips 66 brands not Maxlife. Maxlife is fine for previous years before 2013. Fluid is cheap transmission are expensive.
@DIYTechnician9872 ай бұрын
Thanks for the feedback. I did use ramps and fluid that says it is for Mercon LV vehicles. I also followed the steps the Haynes manual laid out.