Thank you. Don't think I could have removed without your video.
@joshuayoungblood86342 жыл бұрын
Thank you just bought a 2017 and tank is rusty it sat in barn for almost 5 years
@rws533 жыл бұрын
There is no "special" tool needed. And you do not pop off (remove) the yellow plastic piece. See the following link i.imgur.com/AnxCUTB.jpg Top picture - press the tab in. Bottom picture - press and hold it in while working the connector off the tank. To re-install just push the connector until you hear it click.
@ArchesMechanic3 жыл бұрын
Mine wasn’t able to be worked off by just popping it up. I had to completely remove it before it released. Maybe just a bad part installed from factory.
@rws533 жыл бұрын
@@ArchesMechanic You don't pop it up. See picture link in my post...top picture press the tab sideways like the horizontal arrow shows. Then on the bottom picture...press fitting in like the vertical arrow and hold it in while sliding the hose/connector off like horizontal arrow.
@imbored895 Жыл бұрын
@@rws53 Appreciate this comment! Definitely just saved me some frustration doing this on my Rebel 1100
@willsnewchannel4469 Жыл бұрын
Yea, there's more than one guy on KZbin that ill advises about that connector. Thanks for the proper way.
@javiervazquez60009 ай бұрын
la bomba de gasolina de la honda rebel 300 2017 es compatible con la honda 500 ? gracias
@VALUETRUE Жыл бұрын
Wondering if you can show how to drain bad gas out of carburetor of the rebel
@gmodesike10 ай бұрын
It doesn't have a carburetor. It's efi.
@warrensteele5644 Жыл бұрын
Hey Dude! Thanks for the video! Do you know where to locate the thermal fan switch on the 17 rebel 300? The wire comes up from the fan under the tank but I lose it from there. My fan stopped working and the fuse is fine so I heard this was the next most likely culprit. Thanks in advance!
@ArchesMechanic Жыл бұрын
Unfortunately I don’t. I actually sold my bike in 2019
@kengilgore59966 жыл бұрын
Arch, Can the fuel tank be removed from the Rebel with out fooling with the quick disconnect gadget? I am wondering if the fuel hose can just be slipped off? My hands are not very agile and I don't think I can unsnap the quick disconnect....
@ArchesMechanic6 жыл бұрын
Ken Gilgore there’s some bolts on the underside but once you remove those I don’t know if there is a gasket or silicone to keep the seal
@kengilgore59966 жыл бұрын
So you don't think it is possible to just yank the fuel line off of the Quick Disconnect?
@ArchesMechanic6 жыл бұрын
No. It’s pressed in there.
@kengilgore59966 жыл бұрын
Thanks a lot Arch....
@PUSHIN_STYLE Жыл бұрын
Did you remove fuel pump and filter? Do you have any pictures or videos?
@ArchesMechanic Жыл бұрын
I didn’t. Just the tank
@PUSHIN_STYLE Жыл бұрын
I just need to know how the filter should be changed
@ArchesMechanic Жыл бұрын
@@PUSHIN_STYLE I believe it’s inside the tank. No external filter
@PUSHIN_STYLE Жыл бұрын
@@ArchesMechanic I know. Will change it
@subparscrub2456 жыл бұрын
Hey, how did you drain the fuel? I’m looking to pull off my fuel tank to get it wrapped this weekend :)
@ArchesMechanic6 жыл бұрын
Subpar Scrub I didn’t. I just ran it low.
@MrJibsIV2 жыл бұрын
Thank you, you saved me.
@Franke8865 жыл бұрын
Hey, I dented my tank so I was looking to replace it with a new one one. How does the pump assembly come out? Can I remove the just the actually tank and swap it with everything connected or do I have to remove the pump assembly and swap everything over off the bike?
@ArchesMechanic5 жыл бұрын
Franke Dechent I’m sure you can order them with the pump and all that installed but when you order a new tank it will come barebones. Everything will have to be swapped
@flyinbrianbmx5 жыл бұрын
hey how was your luck with doing this? I'm in the same boat right now I'm hoping its pretty easy to do. Also its not possible to order the tank with the pump already installed :/
@mikeroldan85305 жыл бұрын
Is the tank removal the same as the 500
@ArchesMechanic5 жыл бұрын
Mike Roldan yep
@EuthanasiA128332 жыл бұрын
@@ArchesMechanic hey man is there a way to get to the ignition switch (trying to get the key code off of it) without fully removing the fuel tank? My tank is full and I cant drain it tbh.
@ArchesMechanic2 жыл бұрын
@@EuthanasiA12833 key code should be…on the key?
@Kevin_Phu6 жыл бұрын
How much fuel came out when you took off the fuel hose?
@ArchesMechanic6 жыл бұрын
Kevin Phu I ran the bike out of fuel before I did this. Not much came out since there wasn’t much left in the tank
@sebastianescudero87123 жыл бұрын
Hello. Thank you very much for the video. It is possible to reach the spark plugs bettet after remove the tank ? Kind regards.
@ArchesMechanic3 жыл бұрын
If you have the 300 you can reach it easy. With the 500 you can still reach them without removing the tank but it’s difficult to do so.
@sebastianescudero87123 жыл бұрын
@@ArchesMechanic ok thank you
@philipj.martinezjr.16645 жыл бұрын
Is this the same procedure for a 2019 Honda Rebel 300
@ArchesMechanic5 жыл бұрын
Most likely
@hector-lee-taylor6 жыл бұрын
Nice, thanks!
@masonmoad5 жыл бұрын
Is it the same to put I back on? Because I found that it was very difficult to put that little yellow plastic piece back on to the fuel hose, it didn’t seem that necessary so I didn’t put it back into place. My bike isn’t losing gas or anything just need to know if that little safety feature is that big of a deal or not
@ArchesMechanic5 жыл бұрын
Mason Moad it’s a secondary safety and it’s a pain the ass! I finally got it in but it took me a while
@masonmoad5 жыл бұрын
@@ArchesMechanic I didn't reinstall the secondary safety mechanism due to the fact that I accidently broke it. luckily I reinstalled everything else correctly and have the fuel line in nice and snug. no issues so far after riding it for about 300 miles (knock on wood)
@10267795 жыл бұрын
Arches Mechanic how did you put it back in. Just with force ?
@boybalisong14736 жыл бұрын
Please post a video on how to change the spark plug on a rebel 500. Rebel 300 was easy because there is enough open space. Rebel 500 has no space so i guess the fuel tank needs to be removed first. Not sure. Please show us how to do it.
@ArchesMechanic6 жыл бұрын
Boy Balisong wish I could but I don’t have the 500. I am traveling to another town this week I’ll see if they can tell/show me and I can explain in a video later.
@boybalisong14736 жыл бұрын
Thanks!
@ranjanthapa74313 жыл бұрын
Hey arches I love your rebel content. I cannot find any video on how to replace ignition switch. Someone tried to steal my rebel and busted the ignition switch. It would mean the world to me if you could upload video on how to replace ignition switch
@ArchesMechanic3 жыл бұрын
I would except I sold my bike. I’m sorry!
@t4ketsuru6 жыл бұрын
do you know to drain the fuel tank with out running it dry
@ArchesMechanic6 жыл бұрын
ShinobuBlade I took mine off and drained it upside down into a gas can
@shushushubombombom2864 жыл бұрын
Thanks, but one question is possible install the tank lift kit on rebel?
@ArchesMechanic4 жыл бұрын
Yueming Chen never heard of it
@vnthanh1236 жыл бұрын
I don't really understand the step needed from 2:42 where you don't have that 'special tool' to the next second where that fuel line is completely dismounted. Can you go into more detail? Thanks!
@ArchesMechanic6 жыл бұрын
Văn Ngọc Thành it’s like a locking clip. Not sure how to explain it. Sorry
@vnthanh1236 жыл бұрын
Guess I just have to remove my tank to that point and see for myself. Great video anw.
@kurtisday23216 жыл бұрын
Is the flasher rely under there too?
@kurtisday23216 жыл бұрын
Flasher relay. Sorry
@ArchesMechanic6 жыл бұрын
Kurtis Day unknown. Sorry
@KenWitThaChoppa Жыл бұрын
If you see this man I just got a 500 2017 and the guy I got it from just had the ignition coils sitting on top of the engine I can’t find a single thing online on where exactly both coils are supposed to go cause it’s Deff not on the motor. 🤣😑
@ArchesMechanic Жыл бұрын
Email me a photo. My email is in the business contact on my channel page.
@KenWitThaChoppa Жыл бұрын
@@ArchesMechanic thank you for the reply. I will shoot pic over to you tomorrow.
@davidmcnamara87592 жыл бұрын
Just warning everyone on here NOT to follow the instruction at 1.52 the white plastic tab needs to be pushed with force inwards which will release the quick release tabs on the connector DO NOT remove the white tab Please see the shop manual 7.6 drive.google.com/file/d/1f_MYojSW9JdmVXzdx5xzXzLyKLkwIa6X/view for reference