2017 Mazda CX-5 Pedals Installation

[@markfinc8656]

So the pedals are guaranteed aluminium? Someone mentioned in the comments they are actually plastic.

[@mokyan7]

Hm. I installed the aluminum Mazda dead pedal (the one with holes) because I couldn’t find a good alternative. You have to remove trim and put a plate under the carpet that you screw the top plate to. Takes time but looks good. I first tried cutting a piece of rubber floor mat and putting adhesive velcro on the back so it would stick to carpet. That worked for a couple weeks, then the summer heat melted the adhesive and the mat piece slid down. Must get super hot in there.

[@cybermx8896]

Same for me, but I just re-glued the pice of aluminium and the rubber piece with that glue used to bluild shoes, and works great

[@ramonvidal6825]

Do you have a video? I ordered mine for the 2021... hoping to install it soon

[@mokyan7]

@@ramonvidal6825 you know I shot video but it was too long for upload. Let me try it again. The paper instructions help a lot.

[@kevinthomson6324]

Umm there’s a peddle missing

[@carlosdelfin511]

In a SUV? I don't think so

[@MiroslavJahelka]

is it same for 2015 model ?

[@bravoexo]

Miroslav Jahelka Any Mazda Skyactiv car, actually

[@TexasEmperor]

Link?

[@bravoexo]

www.amazon.com/SUNDELY-Aluminum-Automatic-Transmission-Drilling/dp/B00Y8NC6YS/ref=sr_1_4?s=automotive&ie=UTF8&qid=1518020902&sr=1-4&keywords=cx-5+pedals

[@SJAutomotiveDesign]

I just ordered the gas and brake covers for the 2020 model. I hope they don't slip while driving. 😂

[@MatthewMoscotto]

Are these official Mazda parts from Mazda ???

[@bravoexo]

They are not

[@diegoamnesia3096]

not my friend this is the alliexpress item, but is good

[@cmdrryzenfoxx2135]

Industry velco would be better to use on the "dead pedal" installation for certain.

[@irenafacelli2882]

did you switch over and eventually use velcro tape for the dead pedal??

[@bravoexo]

Not yet. But it really needs it.

[@really_hue_man]

I have the manual transmission, the smaller brake and clutch pedals are super stiff rubber,. I can't get them on. How difficult was it for you?

[@bravoexo]

AlvynTV you will need to sacrifice some fingers. Or dip in hot water just before applying.

[@CoroaEntertainment]

Just use a hair dryer to heat up the rubber to make it more softer.

[@randyp5521]

That horrible music was totally unnecessary.

[@vince510]

Does the gas pedal extend out a bit since you didn't remove anything? If it does than by how much?

[@bravoexo]

Just abput half an inch, thickness of the 3rd party pedal

[@vince510]

@@bravoexo thank you.