2019 Automata Projects

This was the first year IED at UHS tried the Automata Box Projects.

[@lightningfoxy6776]

How impressive! I liked the dolphin. What type of cam and follower did u use?

[@UHSengineering]

two eccentric cams. Follower was quarter inch roller

[@125992]

Very cool! What are the cams and followers made of?

[@UHSengineering]

3D printed in ABS plastic. Shelled from one side to use less material.

[@user-xy7bt8qg8k]

⚠️ God has said in the Quran: 🔵 { O mankind, worship your Lord, who created you and those before you, that you may become righteous - ( 2:21 ) 🔴 [He] who made for you the earth a bed [spread out] and the sky a ceiling and sent down from the sky, rain and brought forth thereby fruits as provision for you. So do not attribute to Allah equals while you know [that there is nothing similar to Him]. ( 2:22 ) 🔵 And if you are in doubt about what We have sent down upon Our Servant [Muhammad], then produce a surah the like thereof and call upon your witnesses other than Allah, if you should be truthful. ( 2:23 ) 🔴 But if you do not - and you will never be able to - then fear the Fire, whose fuel is men and stones, prepared for the disbelievers.( 2:24 ) 🔵 And give good tidings to those who believe and do righteous deeds that they will have gardens [in Paradise] beneath which rivers flow. Whenever they are provided with a provision of fruit therefrom, they will say, "This is what we were provided with before." And it is given to them in likeness. And they will have therein purified spouses, and they will abide therein eternally. ( 2:25 ) ⚠️ Quran

[@rychei5393]

Though y'all didn't eat ham, but that sure was Spamy. @@user-xy7bt8qg8k

[@UHSengineering]

ABS plastic on our F170 3D Printer

[@ryehlb]

These are awesome!

[@savi5634]

Please tell me how they attached the dolphin onto the followers to make it move like that

[@UHSengineering]

we just loosely attached the followers on the back of the dolphin so there was a little wiggle room. Each follower was on the opposite end of an eccentric cam

[@HushNinja]

whats the software used?

[@UHSengineering]

Autodesk Inventor but now using Onshape

[@ReactionChannell419]

Good video

[@robotciclado6100]

👍👌👏👏👏👏

[@miguelangeltantavilcamarti9824]

Software s name please?

[@UHSengineering]

Onshape

[@skibiditoilettvman220]

2:34 I LIKE THE PIZZA

[@mikegallagher4253]

They're all left handed

[@skibiditoilettvman220]

3:09 it fell