2020+ Corolla DRL LED Strip installation guide

[@danielmolina4171]

Worst video. Why didn't you install while installing?

[@Phileepoh]

Thank you so much brotha🤙🏽🤙🏽

[@fredsknekt]

thanks for the tip about low beam wire

[@haukopkhual]

Is it possible to install hood led light on corolla? I checked online and didn't find any tutorial about it. Can you do tutorial on that?

[@Phileepoh]

I believe it is possible with a magnetic activated switch so when you open your hood the light turn on and off when you close it when the magnetics are together again. Unfortunately I do not have the Corolla anymore. But here is a link to that magnetic switch: Gebildet 3pcs Recessed Wired Security Window Gate Contact Sensor Alarm Magnetic Reed Switch Black,Magnetic Door Sensor, Normally Open Magnetic Switch a.co/d/5xtBHwj

[@VTwin4Christ]

I hate wire taps... They always allow moisture to enter wiring... Resulting in copper inside wire corroding after a year or two. If one MUST use taps.. get the silicone injected kind. So it punctures AND seals.

[@DogsSnipes]

Posi Taps work too

[@DogsSnipes]

Hey, do you have a picture of how it looks at night?

[@Phileepoh]

I do and it looks very clean

[@Phileepoh]

Also I have a video showing my corolla at night

[@DogsSnipes]

@@Phileepoh Just saw it on ur channel. It looks great! I did the reflectors too but the T taps were all corroded so I ended up removing them. However, I did install those LED tail light replacements and they're amazing, Have you thought about doing that too? Also, how did you access the fog lights? I managed to add a couple layers of yellow tint by sliding the tint in from the front side, but my end goal was to swap out those fog lights with ones that have turn signal capability

[@TeJotaOne]

You think i can do this but with the Underglow light?

[@Phileepoh]

Maybe it might be tricky though

[@LostWon]

Great video! Do I need to disconnect battery from my car before I do this.

[@Phileepoh]

Yeah you should always disconnect the negative on the car battery

[@EdgarFroes]

You're a god. Thanks for the video.

[@Phileepoh]

Ha haaa thanks brotha!

[@LEEALANIS77]

How did you disconnect the turn signals??

[@Phileepoh]

You simply pull the harness out, if you have the halogen front turn signal, it may be different than in my video. I had an SE so the front turn signal was factory LED

[@LEEALANIS77]

@@Phileepoh thanks!! Where did you get the tint for the fogs?

[@morffi1123]

I can see wires, I have the same car but I need to know the wires of the car :(

[@Phileepoh]

You’ll need to use a voltage meter to see what wires you’ll need to tap into. Not sure if all cars follow the same light wire patterns if that makes sense

[@morffi1123]

@@Phileepoh bro my car is exactly the same. I would really appreciate if u can tell me al least wish wires go with which one in both sizes. Like... colors. 🙏🏼

[@hondacivicacura]

How they holding up ?? Bright ??

[@Phileepoh]

Yup still bright and flawless going on 3-4 months now

[@EdgarFroes]

@@Phileepoh what about now, 1 year later?

[@E210.VICTOR]

@@Phileepohchecking up 2 years later lol 😅 i have a ‘22 SE