In case of engine trouble and if I need a tow, then my Sea Doo requires a shut-off valve (tow tap) to be turned -- which is not easy with the cover on.
Пікірлер: 37
@skierman642 ай бұрын
I carry a small vice grip with me that has flat teeth to crimp the water line. It serves the same purpose.
@wineofmine Жыл бұрын
Owners manual is saying no more than 5 MPH but the FP 2022 service manual on page 13 says no more than 15 MPH. Which is plenty of speed for a tow anyway. But I'm trying to figure out why we have two different speeds recommended
@marcuschiu1702 жыл бұрын
I installed my tow tap at the inlet if the exhaust manifold, I only have to remove the seat and reach down the side.
@MichaelStraubSeaDooLooper2 жыл бұрын
That would have been much better!
@Rocketman1000R2 ай бұрын
Do you have a picture of it?
@rocksaltrobАй бұрын
Which one? Can you send a photo please?
@thecarolinahoosier3596Ай бұрын
Is a tow tap needed for a closed loop cooling system?
@MichaelStraubSeaDooLooperАй бұрын
It is on a Sea Doo if you want to tow faster than 5 to 10 mph. (Check owner's manual for exact speed)
@michaelquirke12812 жыл бұрын
Nice idea for sure, was wondering if you had access to the ski hole "portal" would you be able to reach it with your pvc pipe if it was long enough or would it be at a bad angle for turning the valve?
@MichaelStraubSeaDooLooper2 жыл бұрын
I tried but the angle wasn't right... But I like your thinking!
@michaelquirke12812 жыл бұрын
@@MichaelStraubSeaDooLooper Is it possible to install the tap on another part of that same line to make it more accessible or was that the only place the dealer could put it?
@MichaelStraubSeaDooLooper2 жыл бұрын
Dealer put it in a logical spot, but I do think it could be done slightly differently to help turn the valve easier
@emu4wd Жыл бұрын
Good thinking. Can I ask where you got the 2nd battery mount or a link? Steve
@MichaelStraubSeaDooLooper Жыл бұрын
The 2nd battery comes stock with a 2022 Sea Doo Fish Pro
@emu4wd Жыл бұрын
@@MichaelStraubSeaDooLooper interesting. have you a trophy? As my sport 22 doesn’t have it.
@MichaelStraubSeaDooLooper Жыл бұрын
Yes - mine is a Trophy, and for '22, I'm pretty sure that was the only Sea Doo to get the 2nd battery stock.
@hankwang29512 жыл бұрын
Killing 2 birds with 1 stone. LOL
@VAriders Жыл бұрын
Couldn’t you just plug the inlet?
@MichaelStraubSeaDooLooper Жыл бұрын
Good question. I'm not sure if it is easy to plug on the inlet side.
@jomjohny Жыл бұрын
Yes but you have to jumb into the water to access it
@txpyroguy8175 ай бұрын
@@jomjohny And even then you cannot access it. Its small holes drilled into the pump housing. Short of jamming a whole towel inside the pump, there is no way to stop the flow from the outside of the ski.
@ylilycam10 ай бұрын
I wouldn't think too many Seadoo (Including myself) would be aware of the over 5mph water/engine/towing deal!.......I m glad i know now thankyou lol
@MichaelStraubSeaDooLooper10 ай бұрын
Yep... been that way for quite a while. Wish there was a better design. Kinda silly
@LifeBeginsOnTheWater2 жыл бұрын
Great idea, just like you were saying it will be a sum-bitch to access if needed while on the water. Hope you won’t find out. Thanks for sharing Billy D
@toant3333 Жыл бұрын
Hey Billy's here everybody!!!!
@kornelkatai441 Жыл бұрын
What size is that pipe so I can put one in as well. I am going to put it up front. If you follow that pipe it will enter the exhaust manifold towards the front battery.
@MichaelStraubSeaDooLooper Жыл бұрын
I'm not sure. I had the dealer install it, and the ski is in storage.
@davepuranen47342 жыл бұрын
Double check the swing radius on the tow valve. It looks like it will hit the rubber drive shaft housing/ seal.you may have to trim the end slightly.
@MichaelStraubSeaDooLooper2 жыл бұрын
Great eyes!!! You are correct... It does rub slightly. Time to get the Dremel out...
@Andrew-mr2dw8 ай бұрын
Does it have to go there or can i add it further up on that hose?
@MichaelStraubSeaDooLooper7 ай бұрын
Great question! When I got the updated plumbing to fix the starting issues last yeat, they yanked out my tow tap. I need to contact BRP engineers on the new recommended placement with the plumbing changes...
@Andrew-mr2dw7 ай бұрын
@@MichaelStraubSeaDooLooperyes let me know if was thinking of putting it closer so all i have to do is take of the seats
@ZioEnzo Жыл бұрын
How are you going to do this on the ocean? It seems like a stretch on land.
@MichaelStraubSeaDooLooper Жыл бұрын
(Sorry - just saw your comment) I agree... reaching down in there in heavy chop would have been nearly impossible. rerouting so the valve is closer to the top would have been MUCH better.
@brandonhenderson7020 Жыл бұрын
Why not just plug the hole from the outside ?
@MichaelStraubSeaDooLooper Жыл бұрын
Great question! My dealer installed it... I'm guessing the hole on the outside is not something easily plugged...
@txpyroguy8175 ай бұрын
The water enters from inside the pump, you cannot plug anything from the outside.