2022+ VB WRX Perrin Turbo Inlet, ETS Intake, Grimmspeed Air Box Tube

[@JoeyJeeeebs]

Perrin could deff use a smaller T fittings. The hardest part of the install for sure.

[@indecisivegarage2389]

Good point the one for the evap solenoid is too big. Also brass fittings would have been nice.

[@jamesstoddard8790]

What adapter did you use to connect the air intake to the Perrin turbo intake?

[@indecisivegarage2389]

@@jamesstoddard8790 I used an ets v2 intake so no adapter was needed. The Perrin inlet slips over the ets pipe.

[@jamesstoddard8790]

How did you bleed the coolant system?

[@indecisivegarage2389]

@ I used a funnel that adapts to the coolant overflow tank. You keep it half full and let the engine run for a while until no air bubbles are coming out

[@f8monty37]

@@indecisivegarage2389 Is the ets V2 intake only for 22+ only? I have the ets intake that's for 22+ but I just bought the perrin tubro inlet V2. I'm not sure if it will fit.

[@indecisivegarage2389]

Hello, I am not exactly sure what you are asking. The ETS V2 fits the VB wrx (22+). There are several Perrin inlet pipe kits. I believe the one I got is the short version that matched with the ETS V2.