280z ProtunerZ Fuel Rail + AN Lines

[@shanenelson4193]

Did your fuel rail come with washers/spacers? It says on their website that it does but mine did not. Thanks!

[@adrianmejia3302]

No it did not I had to go to the hardware store and buy them separately. Luckily I had 1 bolt that fit to use to compare it

[@shanenelson4193]

@@adrianmejia3302 so are the spacers for where it screws in between the bracket and the intake manifold?

[@adrianmejia3302]

So it should have 4 Allen screws that hold the rail onto the bracket. The bracket then has 2 bolts at the bottom the attach to the intake manifold. Mine did not come with the bolts that go into the manifold.

[@shanenelson4193]

@@adrianmejia3302 okay cool just making sure I wasn't missing something. thanks of the help!

[@KSOLE7]

How does it run since installing?!

[@adrianmejia3302]

It’s been running fine but my injectors went out. But it was holding pressure with no issues

[@KSOLE7]

@@adrianmejia3302sweet after watching this video it made me really want to clean up the the look from stock injector set up. Did you have to upgrade ecu for this to work?

[@adrianmejia3302]

@KSOLE7 no since I’m running stock injectors. If you upgrade to higher CC you’ll need adapter plates and low impedance injectors. If you want to do a standalone you could use LS injectors with adapter plates and a 14mm I believe it is fuel rail

[@KSOLE7]

@@adrianmejia3302sweet def going to go your route! Also thank you for the bccd delete tutorial 🙏🏼🙌🏻

[@darrylleigh7514]

This pains me to watch