i am going through this with a co-workers car. he has a 2002 toyota camry with the 2AZ-fe 2.4L 4 cylinder. i went online and bought the NS300L kit from Huhn Solutions for $375. it comes with everything you need including a jig to make sure you are drilling a tapping perpendicular to the mating surface. i highly recommend it.
@RonZ74 жыл бұрын
Can you keep driving it as long as the coolant level is fine?
@Connella20084 жыл бұрын
@@RonZ7 under what conditions are you asking about?
@RonZ74 жыл бұрын
@@Connella2008 I have a 02 camry with stripped headbolts. Is it safe to drive as long as i keep the reservoir full and drive it under 3000rpms?
@Connella20084 жыл бұрын
@@RonZ7 my coworker was driving for an unknown amount of time on his stripped headbolts. he had no signs of the damage other than leaking coolant. as long as you keep an eye on the coolant level and the temp gauge, you should be ok. however, you really should get it fixed since topping off the coolant constantly is going to be costly. you will also be losing compression so you might get check engine lights.
@RonZ74 жыл бұрын
Connella2008 My mechanic said just replace the gasket and bolts. But if the block threads are worn out I really need to consider time sert or helicoil right?
@ericleger81584 жыл бұрын
Forget about helicoils, use Time-serts. They are so much better!
@TeamGambleBMX6 ай бұрын
Hi @noBulldustTV. I'm in New Zealand dealing with this same issue (using Sutton Tools/ReCoil M11 x 1.5mm thread insert kit). Where did you source that Tee-Bar extension for the tap. Any help gratefully recieved
@jf48725 жыл бұрын
A Timesert is the proper one to use for that repair rather than the Helicoil.
@63Seddy5 жыл бұрын
He probably didnt pop that tang off to well and its partially still hung on the helicoil
@sethat8e10 жыл бұрын
Kindly show the cameraman where the microphone is. Please.. thank you.
@perrysouvana11374 жыл бұрын
I need to do my Camry 2006 2.4L engine could anyone tell me the size of head bold to buy and the kit of timesert. This will be my first time doing it. Thank you in advance.
@jojoocampo3394 жыл бұрын
Where can i buy that helicoil in the philippines
@markkristofferloredo36385 жыл бұрын
Is that an M12? Helicoil?
@justinfore1640 Жыл бұрын
M 11x1.5
@ubaldopacheco15308 жыл бұрын
hi where you buy the tools for the tap ,this tool have part number thankyou