This video will show you how to get from a 3 point problem, to strike lines, an outcrop pattern, and apparent dip of the unit as viewed along a line.
Пікірлер: 17
@samuelasare21902 жыл бұрын
Thank you very much
@normangrimes48693 жыл бұрын
Can you calculate the thickness of unit B and D for this map? please
@rajkumarsiringi67773 жыл бұрын
Thank you so much
@kristeldejan8474 Жыл бұрын
Up
@rubenaguilar1360 Жыл бұрын
What dictates moving from point A to B as opposed to going from B to A when placing strike contact?
@zeags8 ай бұрын
i am also confused by this
@nwankpaprecious82 Жыл бұрын
Sorry but i'm confused, how did you get the units for A,B and C to be 100, 20 and 200m respectively?
@viktorbarruel5968 Жыл бұрын
it is given in the problem sir
@sixtusbambol92074 жыл бұрын
Thank you for the Video Mme. Please your Volume is very low
@everettleslie693 Жыл бұрын
What we’re the units before that made her multiply 30 by 38.5
@accaribo2022 Жыл бұрын
Honestly? Metric field data and then working in feet and inches? Only in the US......
@Yulanli-ne2whАй бұрын
I am not sure how you draw the 1000m strike line.how do you find that point on the left. Why It is 1155m from the 800 strike line ( also point A) and horizontally and vertically? I understand it should be perpendicular to the dip
@sjgeo6913 жыл бұрын
was the last equation supposed to be 9.6 instead of 9.8 for apparent dip? thanks for the video
@kc_structuralgeology69923 жыл бұрын
No, you want to make sure you are using your true dip value in that equation, which is what I get in the work for the bottom triangle on the right hand side of the page. Good question.
@sjgeo6913 жыл бұрын
@@kc_structuralgeology6992 ok thank you that makes sense, in the video you say apparent dip but use the Tru dip value, thanks for the clarification
@ghidimark86713 жыл бұрын
Nice but get a normal ruler 📐
@ryanc.6723Ай бұрын
It is a protractor and the right tool for many mapping calculations.