350Z GKTECH HANDBRAKE

Install of a gktech console mount handbrake and dual caliper set up. Also some clips from my first drift event.

[@aleemrahim6846]

Best video for inside console install 👍

[@brandonhopkins2510]

Clear vid no BS no Frills i like it!

[@initiatedrift]

Thanks man!

[@radieyevanov]

Nice vid man. I have the gktech set up in my Z. How did yours hold up?! Love the handbrake and shift knob matching look!

[@initiatedrift]

I didn’t get to use it much before I sold the car. Focusing on getting my 240 finished.

[@z33_melo]

the white box stays plugged in being tucked like that ?

[@pigbunny]

is it the same calipers than the original ones ?

[@austinthreadgill8415]

Oem axle and Diff? What size axle spacer did you use?

[@brettjohnson4206]

rotors on backwards, lines point back

[@jackturner7992]

How did you actually adjust the handle to get it where you wanted? I tried threading it farther in so that the top wont touch my center console but it wont thread in any farther and it is still pretty close to the center console

[@initiatedrift]

If I remember correctly, I think I cut the threads so they were shorter. Then threaded it on

[@jackturner7992]

@@initiatedrift also did you have to cut the center console (the piece with the cup holders)? Looks like I’m gonna have to in order to fit it around the handbrake cause there’s a bar that goes across it

[@initiatedrift]

No you shouldn’t need to cut that. If you want, send me pictures on my Instagram @s13_straub

[@jackturner7992]

@@initiatedrift all good I already cut it lol, thanks for the help

[@P.roject_G]

Oem axles??👀

[@drift240sx9]

What axle spacers did you go with

[@initiatedrift]

I got the 10mm spacers

[@drift240sx9]

@@initiatedrift thanks

[@josesaldana5914]

What size axke spacers did u use

[@initiatedrift]

10mm