391MG Tech | Pulling the MGB rear axle half shafts

John Twist of University Motors demonstrates removal of the rear axle half shafts from the Tubed type / Salisbury / GT differential. It is easier with a slide hammer. But if you don't own one, you can use two threaded rods to push the half shaft from the axle housing.

[@alanvinegar5729]

Hey John, thanks for the acknowledgement

[@stuwhite2337]

"Hit it with a hammer and it slips right off" 😂😂. If I didn't know better I would doubt if John had really ever worked on a B.

[@steveporritt1550]

After removing the nuts on the bearing retainer & putting the nut back on the half shaft loosely, then bolt brake drum on backwards & hit the drum with a hide hammer & the bearing will come out.

[@MGB-learning]

Outstanding video and presentation.

[@jbstepchild]

Amazing an you could make your own slide hammer alot cheaper with just some stock an some time but who needs to do that

[@Cell1000bc]

How does the slide hammer method look like?