Dave Lenger Jr. 4 hours ago @Mayo Cars DR Great video, yes thanks for getting back to me. Again I have a 2013 Toyota Camry 2.5L (2AR-FE) and i am trying to find a known good waveform camshaft and crankshaft correlation. I was hoping to put it on the scope instead of taking the time to remove everything to align all the marks. If i put it on the scope I would not have to take anything off. It would be a real timer saver. As I have several vehicles that I must get out. I was just hoping that you could help me out? The video of this vehicle was very informative as far as showing all the timing marks. It is perfect. Just let me know if you might be able to help me out. Thank you for your videos and knowledge.
@MayoCarsDR3 жыл бұрын
This video contains all the information, 2AR Engine Reassemble repair manual kzbin.info/www/bejne/pKjKoJ2OpbKAp5o
@amjadyousaf4453 жыл бұрын
It’s really good and very informative
@MayoCarsDR3 жыл бұрын
@@amjadyousaf445 Thanks a lot Sir
@tonytran4857 Жыл бұрын
this guy is so stupid timing belt or lifetime
@stellarv568929 күн бұрын
Bank 2 is really easy. Bank 1 (rear bank) is a real challenge. When aligned the service bolt hole is all the way in the bottom while bank 2 has service bolt hole on top easy to accessout. Have to install timing belt and rotate before removing rear bank service bolt.
@brent7261 Жыл бұрын
How do you adjust the lower crankshaft pulley timing if it’s stuck? Thanks!
@godwinpeter92922 жыл бұрын
Nice work, I love this because is what I do for a living
@MayoCarsDR2 жыл бұрын
Thanks for comment
@ArmandoRuvalcaba-hr2qq Жыл бұрын
Exelent video Good Work
@MayoCarsDR Жыл бұрын
Thanks for comment
@benjaminchikasa856210 ай бұрын
Short and detailed ❤
@MayoCarsDR10 ай бұрын
Thanks for comment
@SamuelJames-i3k3 ай бұрын
Nice job 👍
@MayoCarsDR3 ай бұрын
Thanks for comment
@yawlay2946 Жыл бұрын
Thank Sa Yar❤❤❤
@MayoCarsDR Жыл бұрын
You welcome
@ramirocortes68163 жыл бұрын
What happens if I don't put the bolt on the camshaft Because I forgot to put it
@MayoCarsDR3 жыл бұрын
If you do not put the bolt, the position of the camshaft will out and it will have to be realigned.
@ramirocortes68163 жыл бұрын
@@MayoCarsDR ok thanks for taking your time to answer