The dingle ball .... “ it almost looks like the carona virus” 🤣🤣
@AnnoyedCoastalBeach-nl4tm8 ай бұрын
I know this is an old post but I think you should check the ring gaps in the bore before installing on the pistons
@alertgasper10 ай бұрын
If you want to avoid dust and debris in the block while polishing, bolt it to a flywheel and stand it on a workbench. Also, sand in the direction the bearings will turn, because when you stop the polish, it leaves an edge.
@fastfoxstang98643 жыл бұрын
Great videos, about to rebuild my 302 from my 88gt, did you install new cam bearings?
@TheInfamousProject3 жыл бұрын
Thanks, in this case we left them as they were.
@AcostaRaymond3 жыл бұрын
Hi, what products did you use for cleaning the block and heads? Can i use degraser soap and water and then dry it with air compressor?
@TheInfamousProject3 жыл бұрын
I used the varsol tank and also lots of brake clean
@alertgasper10 ай бұрын
just remember the bare metal will start to flash rust, so coat it with something like WD40 so paint the surfaces you wanted to paint (heating them with a torch can wick condensation out of the pores of the cast iron, helping the paint grab and seal) and WD40 (which stands for water dispersal attempt #40) the surfaces you want bare. just remember when you RTV surfaces meant for gaskets, that you clean 'em off for best adhesion.
@Williecash883 жыл бұрын
I’m rebuilding an 89 302 engine. when I got the block back from the machine shop it has those exact same ridges towards the top in a couple of the cylinders as well. Is this something I should be concerned about? Great series btw!!! Very helpful!!! ✅💯
@alertgasper10 ай бұрын
you probably figured it out by now, but as long as the machine shop used a torque plate, and the ridge doesn't hang up a piston ring during installation, its ok enough for a budget build. i like to use a fish scale to pull the pistons into the block rather than hammer them in--so if one piston needs more "pull" to get into the cylinder, i know it's hanging a ring and there's a problem to solve pronto.
@charliebruceortega8447 Жыл бұрын
What ever happened to the 88 GT t top?
@TheInfamousProject Жыл бұрын
Storage!
@20thcenturyfoxyoutube2 жыл бұрын
Dingleball
@ryantaube65463 жыл бұрын
🙄🙄
@pranays Жыл бұрын
I'm calling it a covid hone from now on and it's all your fault.😂😂