#62 IWiss Hexagonal Crimper HSC8 6 6

[@Seteclata]

The FORK terminal would be the most correct for this purpose, but in the absence of it this tubular is better than without any...

[@Bodragon]

The 6-6 stands for 6 ridges, 6 sides. The hex one. The 6-4 stands for 6 ridges, 4 sides. The square one. >

[@rich1051414]

Now they have 16-6 versions.

[@exogator]

There are 3 standards, two German and one French alot of sizes cross over between but then again alot don't. Makes it hard when you need to work out what system the previous person used when working on stuff.

[@yousaf.saleem]

for screw terminals use ring or U crimps.

[@Omnivorous1One]

Do you need to get a square & hex crimper or can you use just a hex? Are there terminals/connectors where a hex would not do & you have to use a square or the other way around?

[@stryder751]

either will do

[@WaschyNumber1]

Very nice video 👍 🖖

[@WaschyNumber1]

Iwiss makes really nice plier tools 🤗 Do someone know maybe, is ther a difference between the coatings the black and the silver, I have seen also a darker metal coating and the jaws are they differences in the Metal quality, some are too this brown colored ones and so on also some have the Jaws angled is ther a Difference too in crimp quality? 🤔

[@fel8589]

Hi it crip spade or straight jointer

[@james10739]

I was looking to see if there was much of a difference between the 4 teeth vs 6 teeth i have a cheap kit that came with a 4 and i assume the 6 is better and was thinking of ordering one but also i dont think it would make much of a difference

[@stryder751]

I have never used the Square crimp (4-tooth) but I would imagine its not much different. They are however fairly cheap so why not grab one and see if you like it better.

[@franzotto448]

8:00 Künstler oder Akrobat 8:00 artist or acrobat was du gezeigt hast gefällt mir, I like what you showed

[@roncooke2188]

Should be copper