66 Corvette Power Steering Upgrade

Today we give a very nice power steering upgrade to this 66 C2 Corvette. We were told it "bolts right on" but will it actually bolt right on? Lets find out...
Other videos you might like:
Chevy Nova Build Part 15 - • Waiting on parts! - Ch...
Turbo LS3 Build Part 3 - • Turbo LS3 Build - Part 3
Here at ZHP garage, we do it all. Tune in every week for a look into our custom builds, arrays of car shows we attend, general service/how to videos we make, and multitude of races we participate in. We have over 25 years of experience, and can work on anything from the daily commuter, to a custom fabricated roll cage, to a custom Chevy C10!
For behind the scenes action, more look into our builds, and things not shown in the fully released videos:
Follow us on Instagram:
Camera Man: / rhziggy
Master Mechanic: / zhp72
ZHP Garage: / zhp_garage
Give us a like and check us out on Facebook:
ZHP Garage Facebook page: / zhpgarage
#zhpgarage #c2corvette #powersteering

[@johnziegler204]

This video definitely steers me in the right direction.

[@williamsullivan9323]

excellent video but I think I'd stick with manual steering and build up arm strength

[@ZHPGarage]

Always good to have arm strength

[@pumasisneros1]

Just another vette for the Bow tie king

[@RealGenX]

Always a good idea to clean your hole if its dirty

[@TheAndrewShows]

Nice job! What’s the total cost including parts and labor?

[@williamsullivan9323]

I wonder if you can turn the steering wheel if the electric motor isn't working since its a worm gear mechanism?

[@bengone3349]

There is no electric motor!

[@1channeluser]

What's the update on the nova issues?

[@ZHPGarage]

We've had little time to look at it, but we think we found the issue

[@user-zp6tu3fk5m]

I would have stayed with an orginal OEM set up. No need to then fuss with a steering box change and cutting the steering shaft.

[@stonescookinngrillin5555]

You should build a boxer engine

[@ZHPGarage]

I don’t think I’m picking up what you’re putting down

[@rbrewer47]

It takes 10 minutes to take the column out, much easier than sawing in car

[@ZHPGarage]

Hacksaw was the only cutting tool we had on us during this job, so we just left it in the car to make it easier to hold.

[@JR-ut1yx]

Nice but definitely devalued the car.