8-Bit Cutting Board - Builds - Everyday Makers #34

[@dewaynemoore891]

And I thought my shop was cluttered. But that's a real nice cutting board man. Great work.

[@theeverydaymakers]

My shop is DEFINITELY next-level cluttered. One of the hazards of running multiple small businesses out of a one-stall garage. It's very much on my near life-plan to clean it, though. :D Thanks for watching!

[@dewaynemoore891]

A few suggestions, and suggestions are all they are. To combat snipe cut your boards longer then you need and cut the snipe end off. You get a lil waste but a much better end project. And on your glue ups, make a 90 degree jig to build in and use two loose boards on the other ends to clamp. Itll clean up your lines throughout the board. Make em more parallel. Other then that fantastic work man. I love the concept.

[@theeverydaymakers]

I'll have to give it a shot. The tube steel I use usually takes care of it, but I'm always up for a better way. :)

[@not_a_frog]

came out real nice!🤘

[@theeverydaymakers]

Thank you. :) I am pretty pleased with it. It was a fun project. And thanks for watching!