$800.00 Trailblazer Cooling Fan Shroud Replacement

[@FixingWithPassion]

Test drove it past few days. No more over heating. Temp stays pretty normal now even with the AC on.

[@cognac8297]

You already know what im thinking

[@osvaldo3221]

From Enterprise, Alabama

[@FixingWithPassion]

Nice!!

[@williamsparrow6990]

Great job now I have to do the same job in Rocky Mount NC . Thank you.

[@FixingWithPassion]

Great!!

[@osvaldo3221]

I got my radiator change last night, but i could not get the fan nut to screw back in place, also i had so much problem to reinstall the small clips for the two lines at the bottom of the radiator, one of them flu away, i order a new set, now I'm on standby until i get them, i think i will unscrew the base where the line go in and install the clips that way and then screw them back. Well thank you for listening.

[@macweathers2584]

I used a Airhammer to take clutch fan off it came loose almost instantly then just turned clutch fan off

[@FixingWithPassion]

Zzzziiitttt!

[@macweathers2584]

@@FixingWithPassion yessir...lol

[@chasefreeman2429]

I replaced my cooling fan clutch on my gmc envoy and the radiator fan doesn’t want to spin freely do you have any idea what I could have done wrong? Any help is appriciated

[@sionhall]

im about to take the shroud off of mine cuz it warped and is preventing the fan from spinning. question if i leave the shroud off will it be that bad? i know it helps with cooling but if i dont run the air would that be okay?

[@FixingWithPassion]

I would not. Doesn't take much heat to pop a head gasket. Maybe straighten it out some?

[@sionhall]

@@FixingWithPassion okay thanks for the advice! i will see what i can do when i remove the shroud.

[@Type99Arisaka]

Detriot Michigan

[@FixingWithPassion]

Heck ya!!

[@derrickphillips6607]

Battle creek, mi....

[@scottfirman]

If its over heating, the fan clutch is probably bad. Mine was over cooling because it failed and allowed the fan to work all the time. I left it like that because I didn't care if it worked all the time. Of course it threw a code, but It never over heated. You had it out, you should have replaced it right then. They always failed by the way. I went through two.

[@FixingWithPassion]

True. But Mine is new. Only 5 mos old. If you look its still shinny like ;D

[@zeke112964]

You should have cleaned out the radiator fins while you had the fan and shroud out it would have helped keep the engine running cooler. It was the perfect opportunity!

[@FixingWithPassion]

Meh....Actually pretty clean compaired to some Suv's I've dealt with!

[@christopherpivarnik4959]

Long Island, N.Y

[@billfink565]

congratulations on the 55,000 subscribers watching from Middleport,Ohio

[@FixingWithPassion]

;D

[@billbly1691]

Idaho glad I found your channel

[@juiced71]

That’s awesome brother!! I am in the middle of that right now!! Except I am replacing the radiator in my daughters.. I was worried about that damn water pump nut! But did the same as you except I wedged my pry bar into the water pump bolt.. That damn plug for the cooling fan fought me also!! Lol I will tell you that you make it look easy ! Definitely cursed a few times pulling the shroud out!! I may pop a video up of before and after I just don’t have the patience and honestly it would probably be a hysterical video from all the shit going wrong Baah haha!! I definitely appreciate you making these vids! Always good to know what to expect! Hopefully you do a sun roof one! Lol I love these trucks! They look great great and they really do last!! Again thanks Nathan!!

[@FixingWithPassion]

Nice!! Great!!

[@richardslanina440]

You pay to much for parts

[@FixingWithPassion]

Pease tell us more