8FG Instructionals: Setting Up your Gyro Switch

[@heeder777]

Great visual. Helped a lot to get it to work with a micro helicopter that needed a two position switch. Thanks.

[@rc_farmer4866]

AHHH man! this helped me out a lot. I needed a switch for my hydraulic pump and this did the trick. Thanks!

[@robdavtay]

Thanks for the great tutorial. I have been struggling with this all day.

[@brooklandvideo]

Many thanks for this video. Took me ONLY 2 hours to get this right!

[@rtoebak76]

2 position switch is also possible. Just switch around "off" and "on" in nr 1 avcs and nr 2 normal mode. This way always one is "on" or "off". 😀🇳🇱. Thank you very much for the video.

[@PKNEC1]

Great video saved me a lot of hassle. Thanks

[@danestewart2539]

I know this comment comes many years after this video, however this is relevant with modern FMS planes. The ‘Reflex’ gyro requires assigning to a 3 positions with. I am using a 10J transmitter. The 3 modes on the gyro are full gyro influence, optimised which basically means you have control but the gyro will mute the effects of wind etc, and completely no influence. So my question is, what rates should I enter for each switch position considering the 3 modes of the FMS reflex gyro?

[@ArcaneXanth]

Thank you, this video helped a lot.

[@lukaszpiotrowski1584]

Thank You. Is this setting good for Gyro GY611? Do i need to set gain on my Gyro box on helicopter or just keep 100% ?

[@vzarou]

hi could you help me for setup trex 450 se sport i confusing i mix all programing dont know how to return back thanks

[@hawkins2211]

I did all of this but banks dont work on vbar Driving me nuts

[@realchuckwow]

Well it is too bad that you can't see the screen ... At all

[@vandamnjaunclode9813]

your video so funny are you doing construction building lol