Thread Tension Assembly HOW TO: Disassemble, Adjust, and Replace Your Thread Tension Assembly

[@joebernstein2524]

This is one of the best instructional videos that I have ever seen. Everything is explained very well and important points are emphasized and repeated. I can't say enough good things about this video and its presenter. Job well done!!!!!!!

[@loribolden6154]

Again I Thank you for sharing your knowledge and experience.. Lately I am worshiping your knowledge !

[@barbulrey5178]

Thank you so much for this video! My entire assembly came out and I was sewing by pushing it back in every few stitches! And all it took was looking for where the Lock Screen was and tightening it!!! I am in business again. Thanks!

[@indianainnovation8002]

Thank you for this very helpful video.

[@dfrank2044]

Great presentation and well explained from the professional. Thanks

[@hirow08]

Very detailed. Needed the angle of the take up spring. Thanks for this 👌

[@tommyibex2626]

just bought and rebuilt a typical gc0303 and this was the final piece of the puzzle getting it all back together. thanks great video

[@agneskanyamura3849]

Thank you

[@maggiemcallister9972]

Thank you so much!!!

[@tech-teachSL]

Very well-explained. Thank you so much.👍

[@jvcovers1003]

Bro,thanks Gat that problem fix...🙏👍

[@boutch050]

Hi Can u do video on how to set the foot max hi for Adler 269

[@davidsuman2444]

Thanks so much 🙏 Sir . Very useful this video 🙏

[@brianhaddock2020ICU]

Fantastic.. Top man

[@bulusdavou4865]

Thanks a lot

[@MahmoudElganzoury]

What is the best sewing machine?

[@abuhussain26]

Thx

[@ashwadhamini2727]

Thanq thanq....

[@Ben-uf8eg]

i cant get the last peice out. the peice that holds the spring

[@josephpark2256]

Some units have silicone to hold it in or it's just sticky or gunky. Night have to use some needle nose pliers and/or wd-40 to break up the build up.

[@Ben-uf8eg]

@@josephpark2256 used wd40 and two needle nose pliars and still no luck. any other ideas? Thanks for the help

[@josephpark2256]

@Ben you may have to damage it to get it out (new assembly not expensive so be prepared to get that ordered) There is a little hole where the spring comes out. Use that and put a screw driver against there to hit it (clockwise /counterclockwise) to get it to turn and loosen up. With the wd40 in there already it should break up easier once you're able to get it to turn a little bit. PERSISTENCE/PATIENCE IS KEY! Good luck!

[@Ben-uf8eg]

@@josephpark2256 I heated it up with a blow dryer and got it out!. Thank you