Acura MDX Factory Radio Aftermarket Amplifier Installation - Navigation ELS System | DIY Pro Series

[@StevePolychronopo1us]

I bought the harness in the above link for my 2014 acura mdx tls radio and added a subwoofer easy. It works! The factory amp was moved to the center console on the passenger side and i needed to unplug the anc module which was above the glove box. Thanks for making these videos.

[@sonle5260]

Wow you’re a professional, I like your show . I have 2007 Acura Mdx with navy I would like to upgrade all speakers and 5 channels amplifier. I already have 2 set infinity kappa component and 5 channels amp and 10” Jl sub please show me what’s else I need for complete set and where can i buy . Thank you very much

[@lstephenson247]

It wouldn't hurt to set the aftermarket crossover to high pass at around 80hz if you are using a subwoofer. You don't want to much bass comming through the mids.

[@chynoadames1993]

Is that a safe place for the amps? Like for ventilation, so that it doesn’t overheat? Will they overheat there

[@zaytyga]

I have a 2007 mdx. And im looking at the connector on the wiring diagraham that goes to the subwoofer enclosure. None of those colors are on the connetor or diaphragm. Unless theyre labeled something else. The only wires going to the connector is. SW pre in -, WF pre -, wf pre +, B+. Which wires do i splice into if i want to tap the LOC directly from the sub? Do i have to take the subwoofer out the enclosure in order to tap into the signal?

[@josue162]

You said if you the base model you only have 6 speaker. Mine has two extra treeters on the dash. I need a seven channel Amp for the speakers and plus another for the sub

[@jackcarrigan6614]

I’m getting a NG on the sat antenna. Any ideas how to fix the ground?

[@JayyVQ_]

Can y’all do something on the 05-08 Acura Rl ?

[@RicardoGuira]

Where are you located i want to take my acura for a upgrade

[@diannaelimz69]

Could I just hook a LOC up to the rear sub and take the RCAs to my aftermarket amplifier? I want to keep factory sub and add aftermarket amp and sub box

[@AcuraAudioGarage]

yes its just easier to hook up at the amp so you don't have to remove all that trim

[@aidannugent4859]

What if you're using component speakers with an external crossover? Do you need tweeter signal?

[@AcuraAudioGarage]

the tweeter from the factory gets its signal from the FL output of the amp so its the same signal going to the door speaker and the tweeter. So you will already have it.

[@BarneyBorovoski]

can you install this line converter that is upfront on the back together with the amps as well?

[@AcuraAudioGarage]

yes that will work

[@ericauth]

Make shorts with the befores and afters!!

[@jonathanandrade1186]

hey bud, 2014 mdx with navi, is it possible to keep the stock sub and add another enclosed sub with amp?

[@AcuraAudioGarage]

yes but they might cancel out so just run the aftermarket sub

[@pucho513]

What amp can I use to replace the stock one in the 2006 MDX bose non navi. I'm planning to run a separate sub to a CAB 1600.1

[@AcuraAudioGarage]

you can use a 4 channel amp and our bypass harness or a 5 channel for the whole system

[@pucho513]

@@AcuraAudioGarage thanks papa, keep putting out good videos and help for the community 💪🏾

[@pucho513]

@@AcuraAudioGarage I also noticed that the stock Bose sub hits harder than my skar ma8 at volume 10. I have to turn up volume to around 20 to start hearing the skar but the stock sub still hits over the skar, any suggestion?

[@AcuraAudioGarage]

Check out our website for the amplifier bypass. mobilemaxcaraudio.com/product/2007-2008-2009-2010-2011-2012-2013-acura-tsx-amplifier-integration-harness/

[@luisfeliperangel5694]

Does this work on a 19 TLX with navigation ELS?

[@AcuraAudioGarage]

yes but highly recommend a DSP

[@chyanefox46]

How do i just install a subbox and amp without effectively messing with factory radio and nav

[@diannaelimz69]

Did you figure this out.