Add 8 more Inputs for Mach3 Red (RnRMotion) - Wiring and Config

This board has only 4 inputs and 4 outputs and maybe we want to add some extra buttons like Start , Pause and these 4 inputs just not enough. But It has some hidden inputs , what is I say you can add 8 extra input (just as general inputs purposes)??
Yes , there are extra pins on board and we didn't notice!!
these pins are for MPG (handwheel) but the documentary of the board mentions these feature .
when I was searching about the wiring of MPG ( • Mach3 MPG Wiring and F... ), I just found this feature …
In this video I will show you all about schematic and wirings and also configs in Mach3 software.
All OEM codes can be find Here:
drive.google.c...
In the near future, some tests will be done about Jog Handler and if everything works correctly, video will be release too.
Music: Azimov - Broken Heart

[@tobybayliss-fd3dz]

hi great video thanks. were did you get the input cable and board from?

[@manifa59]

Socket name : 10x IDC connector Cable name : Ribbon cable

[@Kr0NiCP4IN]

Can they be used as limit switch connections?

[@manifa59]

Hi Let me try I guess you can use them , but I do not recommnd to use them for any uses like limit switch , these pins are not isolated with opto and have 5v voltage level to operate.

[@insolence1335]

Amazing job. I have question is it possible to use this on proximity switches

[@manifa59]

Thanks. In the manual, it mentioned that these pins can be used just for general inputs like buttons and also not suitable for limits. but if you want to use it for other purposes, let me know And I can test it for you.

[@insolence1335]

@@manifa59 thanks for answer, it was all I needed to know

[@sachiramalinda8396]

Is tis work x,y,z movements.

[@manifa59]

​@@sachiramalinda8396yes , see my other video , I have done it.

[@thanhvannguyen307]

Hello, can I enter the oemled code in the trigger to control the LED? But I measure the volts right at 24V and In1 (I set it up) and it does not output 24V regardless of whether I activate the signal or do not activate the signal. pls help me. tks 🥹

[@manifa59]

These pins work as Input not Output to turn the LED on or off. But you can use them as an input signal to turn the LED on output .

[@sachiramalinda8396]

Is this work x,y,z movements

[@manifa59]

Hi you can use these pins for axis movement but not with this video configs , wait for the next video about jogging .

[@sachiramalinda8396]

@@manifa59 okk