Adding an IDNet Point to a Simplex 4010 Fire Alarm Control Panel

[@nm4fsv684]

On the road to 1 thousand subscribers! Awesome video as usual!

[@pietervanham6223]

Cool

[@evanbart4109]

Nice!:)

[@Wmofnmproductions]

First. And awesome job

[@alarmtech5909]

so now my question is: where do you wire the idnet device to the 4010?

[@FireAlarmsandSuch]

It would be through the main SLC loop on the panel. Its the terminal block on the top far right corner.

[@alarmtech5909]

So through terminals 1 and 2 then?

[@jeacre]

My 13 year old grandson just got a 4010. So far we've learned to do a manual evacuation with an alarm attached. The panel will not allow a quick config. Can you tell me how to overcome this? Thanks

[@Roxxofoxxo]

Are you in level 4?

[@mylestech7301]

What was your very first fire panel?

[@FireAlarmsandSuch]

The SK-5208! Great starter panel!

[@mdatif894]

What is I'd net card please help me sir

[@FireAlarmsandSuch]

An IDNET Card is what drives the addressable SLC loop of the panel.

[@dannyagustianrachman4082]

hello sir. i have simplex 4010 device, and my question, can you tell me how to adding firing sensor in new address with basic programmable like your video ? thank you, i will subscribe if you help me