Adjusting trimmer line height on a Craftman walk-behind Weedtrimmer 22 inch

[@sandralewis1689]

Loved how straight forward and clear you are. I'm just learning to use my trimmer and finding out how to disassemble to remove tangled grass is a BIG game changer for me. Thank you.

[@witch5884]

Excellent video! I had to replace the carrier plate , one of the tabs holding the line finally broke off after 20 years. ordered a replacement but not the mechanism to adjust the height. Disassembly was what I needed to replace it.

[@sheri023]

Thank you, I didn't know it could be adjusted; now I know.

[@jpoppiejaun35]

Thank you, I did not know that you can adjust the height since I bought mine used, but in great shape

[@drivanfig]

Make sure you clean the assembly. It happened to me that I couldn't adjust the base because the amount of grass in the base. Hope it works for you. Thank you for your comment!

[@TerrellWillams]

Thank you! 🙏🏾 Great video and very informative!

[@Jolynn133]

Excellent Video!! Thank you!! You make learning a breeze!! The button on mine is frozen? I can not get it to budge. I've used WD40 waited for hours and nothing. Guess I'll take the ole hammer or sawzall and cut it off. I have the replacement.

[@johnnygoins7457]

Thank you for that it will save some torch work and save the trimmer😅😅😊

[@cesarnavejar1016]

Thank you. This helped a lot

[@PATRICIAJANISE]

How do i remove carrier plate to replace it

[@kriswhartonful]

How do I remove and replace the entire assy. I have the ball off, but there is a bushing on the shaft below the assy. It's bigger than the hole in the assy and NOT moving at all.

[@drivanfig]

Unfortunately I don’t have that information.

[@DoughBob86]

How would you lock the shaft from spinning for removing the nut on the bottom?

[@drivanfig]

The nut is not crazy tight. Just hold the bottom part with one hand and use the rachet with the other one. At least it worked for me. Thank you for your comment!

[@DoughBob86]

@@drivanfig thanks! Apparently ot wasnt the bolt being too tight. The bearing in the thing is fused to the shaft and half blown apart 😆

[@pastorlugo121]

Thanks for this video. I just bought one of these machines and was wondering the same issue. Your just answered my question.

[@marcocasillas5023]

Thanks I just got one and the guy didn't know nothing about it and neither do I thanks for the help