Shimming the valve spring on the Hatsan Gladius and Chronograph test 08 09 18

[@markhomer7628]

My new brocock bantam sniper was erratic just like that , and that was with the Huma regulator in ... Took it back too the shop ( too be honest , unless you have a Chrono too test your equipment you wouldn't know the difference down range , well up too 30 yrs as was ) turns out it was a " sticking hammer spring " ( or something like that ) it's ok now I think , just gorra test it extensively ) love your shows , real down too earth ( and for want of a better phrase ) a working blokes channel ...

[@casperboo5465]

That seems better than it was Mark, hopefully it wont be to long before you have your new air cylinder, cheers

[@erasmoalaniz]

What size was the washer?

[@joellecotton5506]

if your using a regulator, then the big o ring has to come off so the cylinder can breath

[@tinabates542]

I put a huma regulator in a coyote took me 4 weeks to get right now its perfect its in 177 I get 10.9to 11 lb with 8.64g field target trophy and 11.2 to 11.4 in jsb heavys but the field target trophy are so accurate at long distances I was surprised but my coyote also loves jsb heavys and hades and accupells but the accupells are only on 10.6 to 10 .7 lbs but also very accurate

[@lesterkirby3367]

That going to make it worse put the washer be tween spring and end cap other wise tke valve shaft to short when hammer hits it . that wode be the way i go no massing with hammer spring ajusting .

[@netanskizelensky9940]

hatsan air cylinder has bad quality.try to put a regulator in it and several months you will notice a swell near the portion where regulator is placed.i got an at44 tank and its no good.

[@nickathome1]

Think you need to buy better quality guns!!!!!!!