AIYIMA A08 Pro Power Amplifier Review

Aiyima A08 Pro 2-Channel Audio Amplifier Review. This amplifier comes equipped with TPA3255 class-D power amplifier. Each channel can output 300W(4Ω Load) and 2x150W unclipped into the 8Ω load. This is a great, small -footprint amplifier for desktop or bookshelf passive speakers. This is not a paid promotion as I have purchased everything you see in this video myself.
Music: Unisho Reason by Z8phyR is licensed under a Creative Commons License.
creativecommons.org/licenses/...
Support by RFM - NCM: bit.ly/429lUoT

[@Matt-hg9mi]

What cables are you using to connect your amplifier to your jamo s 803 speakers?

[@4han_t]

I purchased 12-gauge KnuKonceptz speaker wire from Amazon along with banana plugs and made my own speaker wires.

[@dmitry516]

Регулировка басса на слух сколько ГЦ поднимает, не гудящий басс получается есть его добавить почти на всю? Ради басса хочу его купить вместо fx 502s pro.Колонки корал х7 у меня. Спасибо за ответ

[@oninzjounique6407]

hi i have question pardon i dont know more about this connections. i just want to ask if i can connect 4 pcs bose 251 to this amplifier? thank you

[@4han_t]

Hi @oninzjounique6407 you can connect the Bose 251 speakers to this amp but the amp can only support (2.0 with line out for active subwoofer) so you can only connect 2 speakers (left and right channel) to the amp. The speakers are rated at 100W nominal and 200W peak at 8Ohm, so this amp can drive them quite well. You could also use the aux out to connect another amplifier which could then power another left+right channel set of speakers. However, make sure not to exceed 32feet of wire length from amp to speakers. Hope this answers your question.

[@jd5787]

Hi, i have a creative labs X3 paired with edifiers (optical connection) and a subwoofer (wharfedale sw150). What would the ao8 do that the x3 doesn't please? (total noob...). Thank you

[@4han_t]

Hi JD. Most likely you have active edifier speakers and subwoofer that plug into a wall outlet for power and get the audio signal from your X3 which is a DAC/Headphone Amp. However, if you had passive bookshelf speakers that didn’t plug into the wall such as one the I have in this video which are the Jamo S803, you need these speakers to be able to get the power and audio signal through a single source via the banana plugs. Here is where an audio amplifier like A08 comes in handy. It’s a Class D amplifier so it’s capable of outputting up to 600 watts of power in a small footprint with high efficiency. And to connect to the subwoofer, I’d just take the 3.5mm line out and plug into a powered subwoofer like your sw150. Hope this helps.

[@Gary_J]

Why are you using external DAC?

[@4han_t]

Mostly to get better audio quality for my headphones as the internal DAC isn’t that good. But same answer applies to when I use speakers too. I can get the source audio signal via usb and let the Fiio DAC handle the conversion before passing the analog signal to the amplifier.