Mastering DSC NEO: Wireless Programming Made Easy

[@simonmadzime2107]

Well done man properly explained helped me a lot

[@patrickmboweni8620]

Hi yes I need to open some zone that as be close on wireless panel or me to contact my external passive hard wire

[@sovannakdos7856]

Great, now that I know how to add keypad #2. How to add wireless smoke detector #2?

[@fredA1234]

Mostly what I use is DSC 832s in 1832s. Does this program very similar to it apparently they don’t make the 1832 any longer so I need to buy a neo panel for a system next week. Do you think I will have any trouble programming one of these opposed to the 1832. Thank you.

[@AlarmSystemStore]

Yes it is very similar. Most feel it's easier in fact because you can see more detail in programming.

[@aghorijay]

Hello, my panic buttons aren't signaling my siren to turn on. Neither the fire, medic or panic button turns on the siren. They are all set to on. What am I missing?

[@Zinc72]

How do i delete (disenroll) existing wireless smoke detectors from key pad? I am planning to upgrade to newer model wireless smoke detectors as existing ones were installed in 2007

[@JulianReveles-i8e]

Was the PG9862 Ceiling Motion Sensor a 915MHz PIR unit?

[@AlarmSystemStore]

Same as the rest of the Power G sensors. It's a range though rather than a specific frequency.

[@mrmegachingon]

I am trying to do wireless enrollment DSC WS4936 SOME DETECTORS to my DSC NEO system but it doesn't detect it? An Any input?

[@AlarmSystemStore]

A DSC WS4936 is not compatible with the Neo. That smoke is for the prior generation of DCS wireless. The PG9936 is the correct one to use with Neo. www.alarmsystemstore.com/products/dsc-pg9936-powerg-wireless-smoke-and-heat-detector

[@stigertr]

Hi Hayden, Is there any way to keep the Wireless Keypad "armed light" on when the keypad is in the dark mode so that a person can see that the system is armed when they go out a door?

[@AlarmSystemStore]

No, there is no way to customize dark mode for what is visable. You'd have to press a key to "wake" it to see the state.

[@rscmumbai5475]

how to program AES 3015 PSTN Receiver with DSC powerSeries Neo Alarm

[@jeremiejagan1602]

Can i add a wireless keypad using DLS5?

[@AlarmSystemStore]

Not certain, we rarely use DLS. I have used it for large systems though and I can tell you that it would take way longer to add a device or two only via DLS. We only ever used it for very big systems. I can hand program even a basic 8 zone system faster manually than I can DLS.

[@danladikanyio390]

how long will the batteries last for the smoke detector?

[@haydenabel2287]

Sorry for the late response Danladi, but the batteries for the smokes typically last 3 years under normal use.

[@tenmoi7564]

How to arm the alarm from DLS 5 1.7 software or from iPhone?

[@alexandersalarms5380]

hi does this connect to a control panel? or keypad only

[@andybowman9697]

Does what connect?

[@alexandersalarms5380]

@@andybowman9697 Does the keypad have to be wired to a board?

[@andybowman9697]

some are wired and some are wireless. Both are shown here, in fact the vid shows how to add the wireless one.

[@alexandersalarms5380]

@@andybowman9697 Ok thanks

[@bobbybenson5741]

Are sirens wireless