How to check Toyota Camry ignition coils/How to fix code p0352/fixing check engine light on TOYOT

[@computerblue01]

I love your channel and videos! Always straight to the point with clear directions. Keep up the great work!

[@AliMECH]

Thanks, appreciate that

[@OluwafemiBoluwaji]

THANK YOU A BILLION TIMES

[@AliMECH]

Thanks for watching

[@opecoassist3784]

As always, Great Job and wish you the Best kak Ali.

[@AliMECH]

Thanks brother ✌✌

[@rayc1503]

Great video bro, I can't say I've ever had this problem before. If I do at least I'll know what to do, kudafis 👍🏻.

[@AliMECH]

Thanks, awesome

[@franciscoarreguin19]

I have a p0302 code I already changed the spark plug, ignition coiland fuel injector and I still have a misfire on cilinder number 2🤷‍♂️🤷‍♂️🤷‍♂️

[@Iknowyoumadnow]

Same shit, like wtf

[@david4062]

​@@Iknowyoumadnow Me too (4 cylinder). New plugs and connectors and coil #2 cleared the P0302 code. In the process, I swapped 2 and 3 so the new coil is in cylinder #3. Two months later I get P0352 (#2 cylinder). Reset Code and swapped coils 1 & 2... Ran great. P0352 returned a week later (#2 cylinder), therefore, it is not the coil (as it is still showing the same cylinder after coils 1 & 2 were swapped last time). Being that the plugs and connectors have been replaced, I maybe have a bad harness or computer. I probably need to go to a shop with an analyzer that's smarter than my better than average hand held. I miss my Plymouth Volare!

[@alexekb196]

Hello, thank you for the information. Camry 50 error p0351 p0352. I checked as you showed, all the coils are working. I swapped coils 1 2 with 3 4, the error is still the same 0351 52. I don't know what to do next. I think I'll swap the spark plugs 1/2 to 3/4. Tell me how to check a working spark plug

[@moonsays1]

Thank you bro

[@AliMECH]

No problem

[@Octillery1]

Awesome video!

[@AliMECH]

Thanks for watching

[@nvembrace]

Great video

[@rusty358]

I swapped coils 1 & 2 and the P0352 error came back. This says the coil is ok and the wiring is intermittent or the ECU is intermittent.

[@Markbabb]

Maybe I need to change my coils my Camry don’t have a check engine light but it has a slight ruff idle

[@jonderrick25]

Did it work

[@Markbabb]

@@jonderrick25 my coils are good bro I think it need a full fuel injection cleaning or some new fuel injectors

[@frankg6578]

Mark, start by cleaning the MAF sensor and throttle body. Then clean the fuel injectors if the problem remains.

[@Markbabb]

@@frankg6578 my coils are good the car is good I live in nyc so I think it’s the city driving that was causing that I’m a trucker I drive my car from nyc to Georgia and the problem is gone

[@volcan3223]

My climate control for my Toyota camrydoesn't work. It only stays on cold and when I switch it to hot it still blows cold air. Any suggestions? Or can you make a video of it. Please and thank you!

[@AliMECH]

I would think about the valve that let's hot coolant to enter the heater core, check that, maybe it's not opening

[@volcan3223]

@@AliMECH do you know where it is located?

[@frankg6578]

Volcan, make sure you are not low on coolant. Also, bleed your coolant to make sure you don't have air trapped in your heater core.

[@imadkhoder709]

Ali where are you from brother

[@AliMECH]

Iraq

[@autoexcellence7358]

Love it

[@AliMECH]

🙏🏻

[@frenchwithmoufdi3776]

Nice

[@AliMECH]

Thanks

[@Markbabb]

I have very poor gas mileage as well even tho I changed the spark plugs my car has 75k miles

[@csun2533]

Me too.but there is no error code in my car. Maybe my car is too old-----180000KM.

[@Markbabb]

@@csun2533 I live in NEW York city but my car use to get better gas mileage now I have to fill up like 2 times in one week

[@AliMECH]

Test the coil like I did without obd scanner , and also I recommend to clean the fuel injection, I have so many videos how to clean even without taking injectors out kzbin.info/www/bejne/n3XPfal5nZl9eqM

[@Markbabb]

@@AliMECH 10-4 will do

[@jonderrick25]

My 16 Camry has been doing this since 2018. No codes at all.

[@nasurdan]

I replaced spark plugs, coil, o rings, and coil and still have code on 2014 mustang

[@AliMECH]

Check the wire harness

[@nasurdan]

@@AliMECH I checked them. I am thinking it's the PCM but everyone tells me it's not