Allis Chalmers 7045 gets a redneck restore.

[@larrystephan1914]

Great job Tim and Bob! The interior and shiny paint really changed the looks of the tractor. Had a fun time visiting with you last week. I always learn a lot when I stop by your place.

[@TimothyFluegel]

Thankyou Larry. Stop by any time you get a chance, but be careful if you stop at the wrong time I might try to put you to work driving one of these beasts 😆

[@larrystephan1914]

@@TimothyFluegel I might just do that sometime!

[@TimothyFluegel]

@@larrystephan1914 especially during harvest lol at any point I could pay ya to disc or Jessi wagons.

[@larrystephan1914]

@@TimothyFluegel Unfortunately I'm going to be helping my neighbor for about the next month.

[@TimothyFluegel]

@@larrystephan1914 I'll definitely manage 😆. The rate the corn is drying I might not be picking until the middle of November again🤦‍♂️

[@familyfarmertn8931]

That cab kit looks really good. I'm a ford guy myself but I always liked the looks of the allis 7000 series.

[@TimothyFluegel]

Thankyou. I'm very happy with the interior, I'll never buy a pre-made one again that's for sure. 😆. I used to run a 9600 Ford I really enjoyed it. Reminded me alot of the 190xt, just overall convenient to run. Not like the red and green ones of the Era for sure lol.

[@familyfarmertn8931]

@@TimothyFluegel I'm kinda partial to the older stuff myself. Not a fan of electronics on equipment

[@TimothyFluegel]

@familyfarmertn8931 you got that right lol

[@williamkemm673]

Good morning Tim, I couldn't find your video on rodent control so I thought I would respond on this one, I just harvested my mint on an area about the size of a half a sheet of plywood and I probably had almost two bushel baskets full of tops to let you know how productive it can be, also I wanted to mention if you mix cornmeal and baking soda together and stick around in different areas the little bastards can't fart or burp so need I explain the outcome for them! Good luck my friend

[@TimothyFluegel]

Thankyou William. I really like the idea of mint planted around. I've got plans to plant it 360 degrees around my shed next year. It's ideas life this is just why I asked to stay a conversation about the little bastards 😆. Some one else mentioned the corn meal and baking soda I really like that too cause if the neighbors cats do happen to eat one they don't get sick that way and I don't have to feel bad 😆 thankyou again William! I will be putting use to both of your suggestions here.

[@dylanhockaday9878]

Hay when you have a chance and you take some measurements off the statom light bracket I want to make a set up for my 7060

[@gleanerk]

7045 l👀ks really great Tim !👍🏻✌️👋🇺🇸

[@TimothyFluegel]

Thankyou Scott!!!

[@dylanhockaday9878]

Can you do a video on the 7045 transmission I gust gat a 7060 with the same one and also how are the weight bracelets on there I’m need to the big allis

[@TimothyFluegel]

The weight bracket in the front just bolts on underneath I Bellerive If I remember right it's 4 ½in bolts that got it on. They could be ⅝. As far as the transmission, are you wanting to see the shift pattern?

[@TimothyFluegel]

The weight bracket in the front just bolts on underneath I Bellerive If I remember right it's 4 ½in bolts that got it on. They could be ⅝. As far as the transmission, are you wanting to see the shift pattern?

[@dylanhockaday9878]

@@TimothyFluegel ok thank you and yes manly don’t understand the 2 buttons in the flore and the transmission booster

[@TimothyFluegel]

The buttons on the floor is high and low like a D series allis, just on the floor instead of a lever. I'll do a short on it and post it later today for ya.

[@dylanhockaday9878]

@@TimothyFluegelthank you

[@farmerpete]

The 7045 sure shined up nice. New cab interior looks great too.

[@TimothyFluegel]

Thankyou pete!

[@brycewiborg8095]

I see you got some rain. I'm in DeKalb. We had lots of lighting, and a 10 minute shower. Thanks Tim.

[@TimothyFluegel]

We did last 3 day we got around 2 inches. Your close by Bryce, one of these five your down here you should stop by for a visit.

[@robertshrawder2934]

You guys did a great job on that cab kit looks real good and didn't cost you no $200 either to do it

[@TimothyFluegel]

Thankyou Robert! I like it allot better than the kits I can buy too!!!

[@kcoers]

Wonderful looking interior!

[@TimothyFluegel]

Thankyou Kevin!

[@garycater4529]

❤

[@TimothyFluegel]

Thankyou Gary!!!

[@mcleanfarmsryan3897]

Another thing I was told that work good is that sound proof foam for music studios but looks good I think it will work to put in all the tractors

[@TimothyFluegel]

Man I've never thought of that. I bet that stuff would be awesome!! Next one I do I'm gonna try it for sure.

[@mcleanfarmsryan3897]

@@TimothyFluegel yeah I know a few guys that put them in the old year around cabs that shake rattle and roll terrible

[@jazzerbyte]

Way cool! The alligator kit adds a touch of class 🙂

[@TimothyFluegel]

😂🤣😅 thanks for clearing that up I wasn't sure if it was class or just plain redneckedness lol

[@clintpaumen1690]

Good looking interior! Will be interesting to see if your home made cab kit lasts. Definetly should be cool to see it in 2 years!

[@TimothyFluegel]

Thankyou Clint, I have faith in my homemade kit lasting at least 2 years for sure 😆 it might be a little harder to clean it but, I don't plan to run this one with the windows open ever lol.

[@stevekeast2297]

Looking good buddy

[@TimothyFluegel]

Thankyou Steve!!

[@southtexashay777]

Nice to give them maintenance. Les problems in the future.

[@TimothyFluegel]

That's for sure take care of your workhorses and they will take care of you.... doesn't matter if they are made out of iron or not 😆

[@craigrasnic4178]

Lookin good there buddy but you’re gonna have to watch it now because if Bob gets in there he will claim it and you won’t ever get it back lol

[@TimothyFluegel]

😆 🤣 😂 I know I told him the same thing, but he's got the one with the 301 in it that he has claimed already he doesn't get 2 for sure lol

[@toddgittins5692]

They're almost giving them away, at mid-west farm auctions. Great for moving snow, log splitter & etc.

[@TimothyFluegel]

They could give a few away to me I wouldn't mind one but lol. I'm gonna have to look them up and see what they've got going on.