AR731TA Complete Unlock - Reload firmware with AR637T version, factory reset via Forward Programming

[@randylervold]

Just followed your footsteps again with both my AR637TA that came in my Conscendo Evo and a brand new AR637T that I bought for another model. Both receivers will not go any further than exact step you complete at 10:50 in the video. Tried both of them multiple times and when I click NEXT at screen that says "Make sure the model has been configured..." it just goes right back to the Gyro Setings screen with First Time Setup option. Could it have anything to do with the fact that I have it configured with the separate aileron wires and set up for flaperons/spoilerons exactly as you depicted in the previous video? Having the same problem with two receivers has me completely out of ideas. I'm using a new NX10SE if that matters. Scientific method tells me that my only choice is to remove the flaperon mods and put it back to stock, which I hate to do but I really need to get this plane back in service. Any other ideas appreciated.

[@GoofballFlyer]

Flaperons are not the issue. I have those setup and orientation works. Aileron settings have nothing to do with receiver orientation. The NX model should not matter. I actually learned how to do all this on the NX8 by watching videos that are based on the IX transmitters. I just finished a video explaining a few more steps you may need to to after a factory reset and will put that on the channel tomorrow. I use my Conscendo with its AT637TA in this video. Orientation setting is part of the process shown. Flaperons are working on mine. Try this: Power up the transmitter and model and go to Forward Programming > Gyro Settings > System Setup > Orientation If you can get to that point you can set orientation with the "level/nose down" method or set it manually. The Conscendo manual setting #3. That's upside down and ports facing aft. Upside down because receiver access is on the bottom of the aircraft and that let's you see the bind button and the receiver orange LED. Please let me know if that works or not. I would hate to be without my Conscendo, I feel your pain!

[@randylervold]

@@GoofballFlyer I tried the step you outlined above, but when I click Gyro Settings I get the "First Time Setup" screen, same as yesterday, no other options. Will look for your next video, thanks!

[@GoofballFlyer]

The video is available at: kzbin.info/www/bejne/mGnSmqKvbrBkkKs