Ask Joe How to Install Lyman's Auto Primer Feed

[@sscottsa]

thanks for putting this video up because i have been having problems keeping the primers in the tube i hope this works. no matter what i do i cant seem to adjust it just right.

[@mariopereira1072]

I have a email into Lyman. Small CCI primers (no. 400) will not come out the end of the small tube after you pull the cotter pin. Only way to get them out is to tap the tube on the loading table. Hoping it's a quality issue that they will make good on.

[@milboltnut]

when arm springs back it throws primer out of sleeve while using the T mag 2 turret press... if you use CCI primers. To correct this I scuffed the sleeve with sand paper and fixed the problem.

[@Silverfish7216]

Would this work on a Lyman spartan single stage press?

[@edkrumm5197]

I have the same press as in this video. The ram lowers slightly when the handle is lowered all the way. The ram raises to it's highest before the handle is all the way down, when you lower the handle past this point the ram begins to lower. Can I adjust my press to raise completely and not begin to lower when the handle is at it's lowest.

[@mikefilmer7043]

My primers are not seating well. What might be the issue ?

[@elijahmonn3757]

Hi, I have an older Lyman single stage press like the one in this video. When I’m setting up my full length die. And screw the die down to the cartridge holder. There is an upwards motion when I lower the ram. It feels like it has a cam? It makes it hard to setup the die according to Lee instructions. Especially lowering the die by a quarter of a turn. Is my press functioning correctly? Or is it supposed to make that upwards movement when lowering the ram? And how should I setup my Lee dies. Thank you in advance, Brent

[@mattp9029]

Now can somebody design a priming system that works consistently for the All American 8? What ships with it is a disaster.

[@FunPrecision]

I have a problem with my orange crusher/crusher 2. When I take the ram to the top point, the ram will start to go down again when the handle all the way down. That makes it complicated to install dies, as I have to visually see when the ram is at is highest point. Is there a solution to this?

[@GunfaceOrg]

Is the arm and feeder included with the T-Mag press?

[@Brainlessoddity]

F.A.C.E. Supposedly it does, but lyman did not send one with my package, and was unable to reach anyone for about 2 days. Just went out and bought a replacement.

[@taylorman1949]

Sometimes(often) the primers seat upside down what causes this?

[@LymanProducts]

sometimes they can flip if you are using the wrong sized tube, if not just make sure you are loading your tube correctly and they should seat correctly.

[@taylorman1949]

I'm not using a tube I'm seating them one at a time.

[@sam-y8t]

Pretty good trolling I've got to say.