With our customers Mark's stock Evo Oil pump being destroyed its time to build him a new one. Check out how we recommend modifying the stock oil pump using OEM components to help prevent failure.
Пікірлер: 17
@danperez39703 жыл бұрын
great fucking video! you are the only one who showed how to lubricate the pump gears located internally. I kept hearing people mention it in other videos or read it on forums but they never showed it. I will be passing the info down to my mechanic with this vid.
@cristianrodrigohuertacovar1998 Жыл бұрын
Hola soy de Chile y se' de mecanica y he visto videos similares y este amigo es el unico que hace lo mismo que yo al lubricar los engranajes y ejes de la bomba de aceite e incluso al reten. Felicitaciones y saludos.
@900whp4 жыл бұрын
You only Line up the dots on the 2 gears if your using both balance shafts ..Lining up them dots puts everything in time 👍
@snailfedperformance71774 жыл бұрын
Thank you!
@jethrox8274 жыл бұрын
Great informative vid as usual mate, I have a question, I've have the oil squirters and the balancer shaft deletes done on a new built 4G63 and have high oil pressure readings on my gauge, 90 psi on cold startup and hot 115 psi at 4k, running 15w50 to protect the motor. No I've done a lot of reading and people say that I could blow oil seals, lock lifters and do bearings, however I can't actually find and evidence of this. So with your vast experiance should I be worried and should I do the porting of the oil filter housing and spring mod?
@snailfedperformance71774 жыл бұрын
It's fine to be a little high, when the motor wears in more the pressure will drop a little, just make sure it's good and warm before you drive it.
@jethrox8274 жыл бұрын
@@snailfedperformance7177 ok thanks brother, yeh warm it up thoroughly, I'm a bit jittery cause I've never owned a built motor so nervous at first in case i hurt it.
@kendeljoseph91122 жыл бұрын
Hey buddy, I tried to locate those straight cut gears by the part numbers listed on them on eBay and on Amazon but no luck. Can you assist?
@snailfedperformance71772 жыл бұрын
Unfortunately no. We have had two sets from Mitsubishi themselves that have been on back order for almost 2 years. The likelihood of finding them nowadays are slim to none currently.
@mgbliz4 жыл бұрын
What’s your opinion on the ER pump gear?
@snailfedperformance71774 жыл бұрын
Never ran one personally. Have never seen a reason to justify it personally. We have ran oil pumps revving the motor to 10k rpm on the stock oil pump gear and have had zero failures.
@titoraps49437 ай бұрын
What is the size of the bolt that goes into the stubby shaft??
@snailfedperformance71777 ай бұрын
It's the same OEM bolt that you would use on the unmodified balance shaft.
@joshuamercado19724 жыл бұрын
Is the oil pump loud with the straight cut gears
@prosportauto49223 жыл бұрын
I did the same thing. A little bit. But you would only hear it if the exhaust is standard (quiet). With any aftermarket exhaust you wont be able to hear the oil pump over the engine noise.
@muhammadnajmuddindin2605 Жыл бұрын
Wht difrent heliy cut and straight cut ..
@snailfedperformance71777 ай бұрын
Helical gears can deflect. Straight cut gears can not.