Atomstack F3 Matrix cutting surface

[@bryanl6100]

Thanks for the additional information. Recently purchased this and watched Steve's video.

[@TheClackShack]

Glad it was helpful!

[@Vintauri]

Good stuff! Thanks for the mention.

[@TheClackShack]

Any time!

[@brad_neal]

Nice demo. Are those available now, and any idea on price?

[@TheClackShack]

Yes, should be a link in the description below.

[@brad_neal]

@@TheClackShack Found it - thanks!

[@EtchinAaronslaserworkshop]

Well just thought I'd let you know I ordered my 20watter from comgrow hope it's what I need

[@TheClackShack]

It's a good module from my experience. Mine is still putting in work.

[@EtchinAaronslaserworkshop]

Just I'm running it on my olm 2 frame

[@EtchinAaronslaserworkshop]

So hope it's okay

[@EtchinAaronslaserworkshop]

Just not sure about the setting up part hope don't fry anything out connecting it 🙏 an connecting it correctly without having to change anything fingers crossed

[@owenauer3406]

A few "things" you missed in your review. First of all you didn't use it with the hold down brackets, the wing nuts of which hit the arm of the Creality Falcon 2. Making the bed unusable. Second, the clips that slide into the bracket are a pain in the ass to keep in position and when you tighten the wing nuts they love to pop out. Third, every other row of teeth is lower than the one next to it, which is basically just stupid, the wood is only resting on every other row, why they did that is beyond me as it makes the already slippery bed even worse. All in all mines going back, which is another problem, I ordered it and it came from California, but shipping it back it has to go to Poland, Shipping will no doubt be more than the thing is worth. Stick with a regular Honeycomb bed and throw the Atomstack in the recycling.

[@TheClackShack]

I did’t miss anything, The device works for me. Not all situations are the same.

[@owenauer3406]

I watched your whole video, you didn't even have the wingnuts and long screws installed. You didn't notice the teeth were not at the same level?

[@TheClackShack]

I did not plan on using the jig leg that it came with. Also, just checked again and all the teeth are level on mine. @@owenauer3406