Audi A4 2.0 TDI P261A00 DTC Troubleshooting, And Fixing,

[@thabob1267]

Will V50 not give the same code?

[@robrob5127]

Hi, Could you please tell me which program you are using ( coolant flow chart),thanks

[@cosmintiganasu6683]

Good evening I have this problem and I have replaced the pump and I still get the error with the engine light on in the dashboard. I have the same engine code CGLC 2012 year. Happy holidays !!!

[@stanhopeautorepaircentrewardak]

Thanks for watching our channel Disconnect N422 (solenoid)located on the bulkhead on the passenger side RH drive vehicle) it is just beneath the water repellent cover beside the wiper arm, and see if if the fuse stays alive because fuse numbers 14 powers up V400 and N422.

[@thabob1267]

Hi, the fuse blows even when both are disconnected. But the fuse only blows when I switch on the heater... ​@@stanhopeautorepaircentrewardak

[@GADbritish271]

Thank you so much ,what is the name of software wiring diagram

[@stanhopeautorepaircentrewardak]

Thanks for watching our channel (Elsawin)

[@uAleks1]

So in conclusion, you can try to replace fuse #14(in the engine bay) and if it keeps blowing, you have to replace the pump under the manifold, right?

[@stanhopeautorepaircentrewardak]

Thanks for watching our channel. This fuse powers up V400 Pump and N422 solenoid. It could be any of them, or the circuit may be short to ground before reaching the components.in my case scenario, it was V400 pump.

[@sosocopacabana2809]

Bonjour, je voulais savoir j'avais un voyant moteur allumé sur ma audi A3 2008 140ch qui m'indiquai la pompe a eau auditionel, du coup je l'ai remplacé par une neuve et ensuite je l'est retirer avec la valise mais le voyant moteur ce remet, du coup je sais pas le problème peut venir de quoi on ma dit peut-être le relais, ou le faisceau

[@stanhopeautorepaircentrewardak]

Thanks for watching our channel. First, check the fuse if the fuse is alive. If the fuse is blown after replacing it, then follow the steps below: Disconnect N422 (solenoid)located on the bulkhead on the passenger side RH drive vehicle) it is just beneath the water repellent cover beside the wiper arm, and see if if the fuse stays alive because fuse numbers 14 powers up V400 and N422.

[@sosocopacabana2809]

@@stanhopeautorepaircentrewardak demain j’irai contrôler tous ça merci pour ces informations

[@belgacemrandi8549]

​@@sosocopacabana2809 what is the name of software Please

[@PalDeak-n9g]

@@sosocopacabana2809 Hi, what was the soulition?

[@sosocopacabana2809]

@@belgacemrandi8549 Bonjour, j’ai utilisé une pièce de la marque pierburg le problème était la pompe à eau secondaire et maintenant tout va bien.

[@thabob1267]

I replaced the pump but the light went off then on again, now I cam hear the pump humming... 😢

[@PalDeak-n9g]

Hi, what was the solution?

[@thabob1267]

@@PalDeak-n9g no change, still the same... The fuse seems to blow only when the blower motor is running and when its set to hot...