How to change front brake pads / brake pad set on Audi A4 B8 Saloon [TUTORIAL AUTODOC]

[@mrget1293]

This is the single best auto repair tutorial I've ever seen and also that is something that I'm going to use, thank you so much!

[@autodocuk]

We are glad that you enjoy our work! AUTODOC

[@SizakeleMadolo-uk5uc]

Beautiful work. Quick question I have done my front A4 Audi 2013 2.0tdi brakes now I clunking noise when driving on bumps. Any pointers please and thank you

[@tipstosoar]

Great video thanks. Also appreciate naming of the lubricants etc. 😊

[@autodocuk]

Yes, recommendations for the use of lubricants should be found in the repair instructions for your car itself.

[@joedredd13215]

Brilliant... just the same as my old 1984 Audi 80 Sport. Thanks 👍

[@autodocuk]

We are glad that this video was useful to you!

[@dylanstoesz1324]

My pads came with some wires that I think are wear sensors. Where do they go?

[@ctime7185]

Are the brake pads the same for Audi b9 models also?

[@autodocuk]

Unfortunately, your car may be structurally different from ours and the replacement procedure will be completely different. Therefore, complete information can be found in the service or technical documentation for the repair of your car. AUTODOC

[@ashwingurung1894]

What is the crowbar for?

[@autodocuk]

Please clarify or rephrase your question, specify the time of the fragment in the video.

[@danielasif3634]

Why did you open the brake fluid lid?

[@autodocuk]

It is necessary to remove the brake fluid cap so that pressure is not created in the system and it is easier to press the brake piston as well as it gives opportunity to monitor the brake fluid level.

[@mohammedr369]

Are you supposed to change the brake fluid? Or leave alone and just recap at the end

[@samgarci1887]

What does it mean socket #13? Is this 13mm?

[@autodocuk]

yes absolutely right.

[@samgarci1887]

@@autodocuk thank you for your reply! This video is very helpful. 🙏

[@sadmachines6991]

Thats not the usual caliper spreader tool. Where do you find that type? I cant find it anywhere. There's no hole in the center of the frame to run a regular spreader

[@autodocuk]

Hi! Thank you for your comment. You can get acquainted with the goods for the car here www.autodoc.co.uk/yato/13639605?search=YATO%20Turn%20/%20Reset%20Tool%20Set,%20brake%20caliper%20piston%20(YT-06822 )

[@todhold2673]

Step one... Use your $100000 car lift to life the car in the air....

[@autodocuk]

Thank you for sharing your opinion! Stay tuned with us. AUTODOC

[@limelightny203]

😂

[@ottoman90atrix]

I have same brakes but i get rattle going over any bump pothole and stops once brakes applied any fixes ?

[@autodocuk]

It is difficult to say something without proper diagnostics, we recommend contacting the service. AUTODOC

[@billkatravas6937]

where can I get a caliper wind back tool like yours?

[@N1GHTHAWK1211]

Most auto stores will either sell or rent them, you can also just leave the piston side pad on, and use a C-Clamp to compress the piston

[@alexey9900]

Good 👍👍👍

[@wilko2907]

Should of put grease on slide pins always when changing pads

[@autodocuk]

Thank you for the valuable clarification, for our viewers it will be very useful information. AUTODOC

[@autodocuk]

Thank you for the valuable clarification, for our viewers it will be very useful information.

[@swebiker2]

Why do you put a square with some text in the middle of the picture when the people watching this are new to this. You are covering things we think we may miss

[@autodocuk]

Yes, we are clarifying what we think you may be missing.

[@BMH1965]

Again, no-one dares showing how to change the rear brake pads...

[@GetRightEarly]

👍🏽

[@borutgoli840]

bad tutorial. where is wear cable

[@SizakeleMadolo-uk5uc]

Beautiful work. Quick question I have done my front A4 Audi 2013 2.0tdi brakes now I clunking noise when driving on bumps. Any pointers please and thank you

[@autodocuk]

There may be many reasons and without proper diagnostics we cannot advise anything, please contact the car service.