Autoflame Servo Motors and Parallel Positioning - Boiling Point

[@boilerspecialists4358]

Great explanation on the benefits of upgrading to a parallel positioning system

[@wareboilers]

Appreciate the comment. The future is now in the boiler room! Thanks for watching

[@mizesagor4273]

Why servo position was high then burner don’t fire? Please explain about it

[@boby115]

Please correct me if I am wrong but on your first boiler I noticed the Maxitrol inches to inches regulator vented into the burner compartment. I was under the impression the NFPA 85 code requires this to be a single vent line routed outside or an approved Maxitrol vent limiter installed. I wonder if you could have one of your technicians or engineers address my concerns?

[@wareboilers]

Had to look into this one for you. So you are actually seeing an illusion of what you are describing. www.wareinc.com/uploads/media/IMG_20190807_135004.jpg take a look at that. You can see our vent lines are going out to vent but then one line is going to the burner for the pilot. They just cross perfectly where it looks like the vent goes to the burner. Hopefully that makes sense now and thanks for commenting!