Thanks man for sharing your knowledge helps me a lot god bless you,
@diy_automotiveАй бұрын
@@betogonzalez617 you're welcome, thanks for watching! If you run into anything or have questions post them and I'll reply as i can
@SquirrelDirt8 ай бұрын
Helpful video thank you.
@diy_automotive8 ай бұрын
You're welcome.
@Gary-zg7pj6 ай бұрын
Good job!
@diy_automotive6 ай бұрын
Thank-you!
@idawave14948 ай бұрын
What did you jack up on? The ball joint bottom or the control arm?
@diy_automotive8 ай бұрын
When re installing the knuckle? The jack was placed under the ball joint, but was more than likely pushing on the control arm. The main thing is to lift the lower control arm so you can align the knuckle with upper ball joint. Theis shouldn't require much pressure but you could place a small piece of wood between the jack and lower control arm for extra safety measures. Hope this answers your questions, thanks for watching.