Awesome video and well edited. I'll be using this to figure out what's wrong. Thanks.
@neroaugustus537811 ай бұрын
For future reference, and mainly just to avoid a tow, if you hit qnd jar your alternator with a hammer/jack handle/etc. just like a failing fuel pump, or starter, for which the same works (i once had my fuel pump go bad, and id hit it a few times with a hammer and itd start right up. Drove it like that for like a month and a half. ) My best guess is it knocks the motor loose enough to run.
@jamescalhoun458811 ай бұрын
Clean battery cable ends and battery post first ! Worked for me. Had a new battery and new cable ends and I guess they had a coating prohibiting battery from m receiving charge
@dougfredricks201710 ай бұрын
Had recently related issues on my 05 Dodge Caravan and retightened cable ends.
@hassanaldossari250918 күн бұрын
Full thanks From saudi arbia... Very good idea
@RenatoEscano-q4q5 ай бұрын
This is very helpful- found the fault on my Holden Captive when I’m driving on bumpy road engine stop. Then when I’m switching the ignition on engine start but there’s no lights on dash. Found out battery ground connection to fuse box is loose connection. Thanks for your helpful advice and video ❤
@Bonbonbon73910 ай бұрын
My problem has been the ground post to the jumper post. The little copper circle kept breaking and my Chrysler 200 would randomly stall. I completely replaced it with a ground cable from Walmart and have not had any problems
@txdunn11 ай бұрын
straight forward, good info. Thank you very much
@churchplant12211 ай бұрын
Thanks for making a great video covering all possible causes for a symptom. I have 2013 t&c, how can I check if mine has the fuse problem?
@levicabahug5482Ай бұрын
Thanks for this!
@JoseSandoval-ic5xe6 ай бұрын
Hi I own a 2011 Kia optima SX and I got these codes C1102, C1126 and B1102 all at same time would you know what is wrong, last thing I replaced was a coil harness connector as when I was checking them by moving them with my hand while car was running and only cylinder 3 it would stumble and I also get a few misfires in that cylinder.
@williecollier5731 Жыл бұрын
Great video ty
@savionawesome4 ай бұрын
I own a 6.4 jeep and did all that is there any other possible outcome. When the car is running I’m getting an 11.6 V Any other recommendations?
@garciafamily58503 ай бұрын
Pcm could be issue. Sent mine to get repaired cost around 250 to send out to get fixed 600-1000+ for a new one.
@garyvu18904 ай бұрын
Can overcharging cause that code issue?
@brunom12806 ай бұрын
2015 Jeep grand cherokee 3.0l diesel. I'm only seeing 13.4 v now. Was at 14.4v. I have checked everything and cant find the issue. I have no codes of any kind. Any thoughts?
@HVAC_Mechanic6 ай бұрын
The alternator rated output needs to be looked up but that sounds like it likely is in the correct range.
@thomashuckaby886711 ай бұрын
Thank you.
@abnerbener Жыл бұрын
Is it possible that code P0562 related to the pcm it’s à dodge caravan 2018 according to my Mecanic the battery regulator is integrated in the pcm Im not a Mecanic and try to avoid changing parts with no results It started with a battery lit on dashboard, and drove until a drainage of the battery when I connected the charge the car started and the alternator was charging and working fine . Drove the car for a test and drained the battery in 15 mn , had to tow the car, anybody got this problem???
@Bonbonbon73910 ай бұрын
I have a Chrysler 200 3.6 and I had the same problem, and it ended up being the ground cable from the battery to the jumper post. It’s super finicky and if it’s not exactly perfect or if there’s corrosion on that little copper circle it can be all kinds of problems like my car stall in the middle of the road while I was driving it it killed one of my alternators, etc.
@isaiahlopez87649 ай бұрын
This code is coming out as pending on 03 dodge stratus
@Cotty910 ай бұрын
2015 charger mine has 5amp yellow battery sensor fuse back fuse box