Where is your gauges. You don’t just assume The switch is bad.
@maxsilva545411 ай бұрын
Absolutley Got sent to a job where diff condomed high pressure cut out switches bc unit wasnt comingnon system was flat ......
@Kilcrops091410 ай бұрын
@@maxsilva5454how was the high pressure switch cutting unit off if system was flat?
@P9rkour904 ай бұрын
Always use your gauges!! But I’m assuming he did already since well, he’s an HVAC technician lol but ya never know….
@craigkennedy996811 ай бұрын
no gauges ? and you determine that an overcharged unit has a bad HPS ?
@kennybakerhvacr5751 Жыл бұрын
If you have voltage going in but not coming out before the HPS are you sure the high pressure switch is bad and not just doing what its supposed to be doing?
@Davidandgoliathhvac Жыл бұрын
High pressure switches are normally closed and when they do open they should close back once the pressure drops below the rating for that pressure switch. This pressure switch got stuck in the open position thus not letting low voltage go through it to the contactor.
@kennybakerhvacr5751 Жыл бұрын
@ramseyhvac I understand how it works. The point I was making is simply that just because voltage is coming in but not leaving the outgoing side of the board is rarely a case of a failed pressure switch. More often than not its something working correctly and protecting something, such as the compressor. Thank you for your quick response. I'm not here to troll. I'm like you. I see a problem and immediately think of the things it could be is all.
@Davidandgoliathhvac Жыл бұрын
@@kennybakerhvacr5751 I hear what you’re saying. And after I replaced the pressure switch, I checked amps on the compressor, fan motor, pressures, SC, SH, Delta T. I also checked the outdoor coils and they where not that dirty. Thanks for the question. We are all trying to learn.
@Weird_1 Жыл бұрын
@@Davidandgoliathhvacthat is the way to check. Also sometimes you can tap on them to free up the switch temporarily until you get a new one
@ramellin11 ай бұрын
Good call 👍
@vitor7954 Жыл бұрын
High pressure is working its the run cap or condenser fan motor what tripped it there is a reason where are your gauges
@darrend203511 ай бұрын
We’ve been seeing the Newer YORK residential heat pumps (2 or 3 years old) with a shit load of faulty pressure switches And yes you have to braze it in 😐
@Davidandgoliathhvac11 ай бұрын
Thanks for sharing I’ll keep that in mind with the newer Yorks!
@omarantonetti841711 ай бұрын
You'd be surprised how many people don't know you can by pass until you return for repair Same with defrost boards 😂😂😂
@7573Dca8 ай бұрын
Definitely dont bypass a lps that could end very badly
@user-be4tu1pq8j11 ай бұрын
Check Continuity
@bottitabaki307310 ай бұрын
Hi. Did you make video for this repair?
@Kilcrops091410 ай бұрын
Turn unit on and condender fan motor is bad 😂
@hvacforanyone859411 ай бұрын
Really-🤔-Interested
@jrsmyth976111 ай бұрын
YES, it is so obvious the pressure switch is bad!!!! It couldn't be that the pressure switch, a safety device, is doing its job. Can you say, "I am a hack"?