Kawasaki Lakota 300 top end rebuild part 2

[@Ford679]

Thanks for the video bud I have a Kawasaki Lakota it jumped timing and I could not remember how to set it but now I remember

[@SandSquatchRacing]

Thanks glad i could help

[@albertobermea9231]

Excelente video, gracias

[@coolgamer5148]

Great videos on lakota I and many others really appreciate the step by step I'm new to four stroke and have many long day's ahead of me on my motor rebuild on 2001 lakota just got the clymer book today ... thanks

[@SandSquatchRacing]

thank you

[@daviddong-v6d]

bayou head bolls have a straight shot in

[@TheRealOman]

Why does the book say there are 3 o rings that go in with the head gasket?

[@tylerharris3907]

Not sure if I missed it but you don't mention resetting the cam chain tensioner. I think somone did the same thing on one i just picked up and over streched the cam chain. Best solution is a manual tensioner but if not it should be reset anytime the cam chain is taken lose or it is removed.

[@metaspencer]

hey, cool channel! lots of fun toys and whatnot to check out :)

[@SandSquatchRacing]

Thank you so much, I have really enjoyed watching how your prison bus is coming along

[@coolgamer5148]

hey I commented on last video of this series and you responded to this thread and most appreciated I have issue with bottom left case where starter gear chain and gear once I put them on together it is binding and not fully seating also prevents my crank from turning due to chain being on starter ????? please help

[@jaycline7303]

I appreciate the great video content. It’s helped me along with my Lakota tip end rebuild. One question I have is about using 3 o-rings on top of the cylinder head gasket. My manual shows this and my rebuild kit came with them. Is this necessary?

[@SandSquatchRacing]

yes they around the alignment dowels to seal them

[@jaycline7303]

Great, thank you so much for the reply. Have a great Thanksgiving!

[@kennethrohe4076]

What are those torque specs again?

[@killerthreewheeler8010]

Would have been nice to see how you got the cam sprocket it

[@SandSquatchRacing]

you just align it and slip it on

[@micah8876]

Lakota continues to rev after letting off throttle. Cable not sticking and cant figure out why. Eventually it will idle back down but sometimes i have to hit kill switch then turn back on for revs to slow down to idle. Does it worse when hot. Could this be a valve adjustment problem? Has a new carb on it.

[@SandSquatchRacing]

i would check the carb slide first just double check that its not sticking, then if its good move on to checking valves

[@micah8876]

@@SandSquatchRacing thank you. Messing around with the carb after cleaning and checking 10 times i adjusted the idle down just for shiggles and what do you the problem went away. It wasnt idling high or didnt sound like it was before but after adjusting it down the quad is running like a champ. Still going to check valves as its jot been done since i have owned it. Thanks again for your help! Now if i can just get the front brakes to bleed after removing calipers to clean and replacing the fluid.

[@rodolfovillalpando2984]

Where do you get your parts for This avt, or if you work fixing them let me know so I can bring it to you, I’m in Oklahoma as well.

[@SandSquatchRacing]

most of the time i get parts online ebay mostly and i have a full time job i get do the ATV for fun