How to Trigger Binary input on relay in pcm600

[@wasimulhaque2862]

It's blur in contrast, so whenever make an video improve your video quality, but your video is very informative. Thanks bro👍

[@baranitech]

i will try to improve

[@meghanasr3098]

Hi sir can u make a video of protection testing of numerical relays like RED670, RET670,REB670. With parameter setting and calculation

[@baranitech]

i will try to make

[@smsaranradzzworld9869]

hi whether it is possible to send a current to scada in percentage of full load current in REM615 relay

[@AdnanJayyousi]

how can I add inputs to OR gate ?

[@baranitech]

kzbin.info/www/bejne/mGOXgKmZgL54ZtU

[@ILAYARAJAraja]

Hi, In REF615 relay trigger continuously breaker on and breaker service signal in the disturbance record how can we stop continuously triggering, I need one trigger only at the time, kindly give the information,thanks..

[@robertozelaya3193]

you are a monster man...i love you 😘

[@baranitech]

thank you and welcome

[@premkumar-xo5iz]

Binary output is not generating by ref615 relay when it receives binary input. How to solve this.?

[@baranitech]

check output in test mode

[@premkumar-xo5iz]

@@baranitech not activating in test mode.

[@ILAYARAJAraja]

Hi how to solve ref615 relay modbus communication failure??

[@baranitech]

i have only very less knowledge on modbus. anyway i will try to find solution can you please tell any error message your getting while. and also please ensure that modbus communication setting are correct

[@ILAYARAJAraja]

@@baranitech ref615 have modus communication to dcs through anybus gateway, profibus communication ok up to anybus gateway converter in between relay to anybus gateway converter, there is communication failure, so how can we solve problem in the communication management in relay

[@ILAYARAJAraja]

Finally answer found- menu-monitoring-communication-modbus-Ethernet-serial-Make it false to true, to enable modbus failure...

[@ZDTcko]

My input stopped working over night. I measure full voltage on +- of the input, directly on relay. Its weird it just wont go from 0 to 1. Never happened to me before. Any thoughts on the problem, could relay input be broken? All setting are correct, on other bays same configuration works. Help sir pls 😢

[@baranitech]

you get any error code message in relay display

[@sureshpadhy2243]

how to assign binary outputs to hardware outputs.

[@pradeepsingh350]

Sir I am unable to read in offline mode .. showing GPST error ...pls help me out

[@baranitech]

MAY BE THE SPECIFY CODE NOT MATCHING