Little confused by this video. Does the MBC you are using have a seperate bleed exit for the air? Because my MBC has one pipe for connection and the other vents the air. So not sure how this would work. Also you mention you have a tune to delete the N75. Some people may not have thst tune so again would this work without ecu issues.
@NayanaMuthu3 жыл бұрын
W
@gerryr18932 жыл бұрын
No
@jonathanbryant1882 жыл бұрын
Vent boost controllers are trash. Wasting boost. Going inline between turbo housing pressure side to the MBC make it in a way where the boost has to be higher to push against the ball bearing and spring to open wastebate
@thegamehud8214 Жыл бұрын
I have the same BC , if I have 2 lines going to side of waste gate , and 1 line going to manifold ,how do I hook this up? Sorry I'm new to this turbo stuff. Lol
@evanwerner46694 жыл бұрын
What about that hose you left wide open on the inlet pipe that you pulled off of n75 valve. Where does that go? Just block it off?
@boostdynamictuning4 жыл бұрын
Yes, just block it off. I did it off camera, sorry about that.
@nieto0643 жыл бұрын
Hey man i have a gli with a k04 and eurocustome tune, the kit came with a mbc, on my gli i already have the Rn75 valve. I dont think the n75 is deleted could i just run it with it connected, but hoses going to the mbc?
@nieto0643 жыл бұрын
*dont think the n75 valve is deleted on the tune.
@gerryr18932 жыл бұрын
@@nieto064 yes I have mapped mine and deleted out n75 so just use the manual boost controller 310 whp
@LilSkrimp692 жыл бұрын
What do you do with the n75 valve plug?
@boostdynamictuning2 жыл бұрын
With my tune it can completly removed.
@Monsterrr69 Жыл бұрын
Can u help me with a tune
@celrolla77603 жыл бұрын
Same way with the Audi TT ?
@boostdynamictuning3 жыл бұрын
Yes.
@troyturner45264 жыл бұрын
Would this be the same for a t3 turbo with an external wastegate??
@boostdynamictuning4 жыл бұрын
Yes, connect it to turbo pressure line and wastegate. You’ll be all set.
@troyturner45264 жыл бұрын
Okay cool, thanks man
@jonathansantiago70564 жыл бұрын
Same way with the b5 Audi A4 ?
@boostdynamictuning4 жыл бұрын
Jonathan Santiago yes sir! Just make sure to plug the hole in the intake tune. Run one line from wastegate, and other line to compressor housing nipple.