I'm in the lawn care business, and I'm making the switch from gas-powered to battery/electric equipment. I use this stuff a lot to clean the connections where the batteries slide onto the equipment. If they're dirty, not enough power gets through, and the equipment doesn't run right. This stuff is better than anything else I've tried for that purpose. I consider it cheap insurance for what is really very expensive equipment.
@christophervanzetta11 ай бұрын
I’d recommend, after cleaning, using Deoxit shield as it’s supposed to prevent further corrosion or oxidation from happening which should keep those kinds of contacts clean for better power delivery.
@kimstockdale632 Жыл бұрын
Use caution on automotive connectors, on a Nissan 3.5L, I sprayed about 5 different engine connectors before remating, thinking I was doing good preventive maintenance. But when remating, I couldn't push them together to get the final mating "click". Puzzled, I blew the connectors with compressed air, left the car there for 2 weeks and surprisingly, when i returned, all 5 remated just fine. I suspect the Deoxit caused the rubber/ plastic inside connector to swell. Later, on a Honda 2.4L i demated the 4 spark plug coil connectors. Again I sprayed each connector half with Deoxit, and again I couldn't push the connectors back together to get the final click. Blew them with compressed air, and since I had access to get leverage on the Honda connectors to push them together, I was barely able to mate them, without breaking from the high leverage used.
@NoWr2Run Жыл бұрын
INTERESTING, T.Y.
@androidemulator69524 ай бұрын
Good to know- thats exactly why i bought the Deoxit for - "old car dodgy / "green crusty" connections .. ;)
@keving520022 жыл бұрын
This stuff really works! Cleaned my old subwoofer bass volume. No more scratchiness or sound drop out. And i couldnt event really spray inside the potentiometer just on the side and on the main shaft. I loosen up the knob an works great.
@Charliehin194E4 ай бұрын
This is a contact cleaner? Any difference from WD40 contact cleaner?
@piconano Жыл бұрын
Have you tried naphtha (camp fuel oil) and cotton swabs for scrubbing contacts clean? Googling what's in deoxit, says %75 is naphtha. Like kerosene and jet fuel, It's a good solvent too. Haven't needed more than 99% IPA and have never tried the naphtha method. Your video showed me I don't need the expensive DEOXIT. Next time, I'll try the naphtha on slider switches and see how it goes.
@andiman453 ай бұрын
Im sure naphtha is there to evaporate after spraying like brake cleaner.
@lindaohara28262 жыл бұрын
What would you use for a DJ mixer covered in dusty fine alkaline sand? D5/D5 mini/Fader or Vinegar/Water/Alcohol or all of the above?
@fuzzylogic3310 ай бұрын
I see nobody's replied to you, D5 be best, just remember you'll have to remove the screws on the mixer and apply to the inner contacts, not like wd40 and just spray inside.
@tonygrooove6 ай бұрын
i will give it a shot!
@sithwarrior Жыл бұрын
I found alternatives to deoxit, MG Chemicals 401B - Nu-trol Control Cleaner similar to D5, so far use this on my Atari 2600 switches, paddle controller and Sega Genesis Model 1 headphone volume slider. the other MG product I use is 801B - Super Contact Cleaner With PPE, does the same job as G5 putting a protective coating on gold plated contacts for games or console cartridge connector.
@christophervanzetta11 ай бұрын
Just checked it out and there’s two problems I’ve found. Costs more than deoxit and DOES NOT remove oxidation, a huge problem in older equipment.
@sithwarrior11 ай бұрын
if you can point to Canadian retailers selling for cheap, I'll get it
@Musicstet Жыл бұрын
Really enjoyed! Great video, you are compelling :-)
@ferenclucas2842 Жыл бұрын
Nice! Don't use d5 on sliders and potentiometers. Fader lube for that!
@readiysteadiy Жыл бұрын
Agreed!
@thomasknutsson7868 Жыл бұрын
@@readiysteadiy Thanks! But what do you recommend for potentiometers?
@Reality_Checkmate5 күн бұрын
@@thomasknutsson7868 Contact cleaner. Move on to the Deoxit Fader F5 if that doesn't work. Lastly, there's the F100 as a last resort. A little dab will do you on the Deoxit though. Don't use much or you'll make a sludgy mess.
@LuisGonzalez-vx1oo Жыл бұрын
Does it lubricate?
@NoWr2Run Жыл бұрын
YES
@davidmorgen45586 ай бұрын
Spray an amp down in after2 years before the corosion Reall hits!
@omegamog6 ай бұрын
Whoah whoah whoah As a retro gamer this scared me. I've only heard of people recommending isopropyl alcohol. I'm scared I now need to spend $70 on these
@readiysteadiy6 ай бұрын
if you take the plunge I'd consider d5 before the gold..... I can find it for $27 CDN at my local surplus store. The biggest problem is the can leaks all over the place....
@Reality_Checkmate5 күн бұрын
CONTACT CLEANER PEOPLE. MOST of this stuff just needs the dirt flushed out. Deoxit is greasy and attracts DIRT. Don't use it if you don't have to. If you do have to use it to remove oxidation, only use the 5%. Rarely do you ever need the 100%. It's easy to make a real sludgy mess with deoxit when you should be using straight contact cleaner.